


















990 Vibration Transmitter
05 0-5 mils pp (0-125 μm pp)
71 7.0 meters (23.0 feet)
01 35 mm DIN rail clips
05CSA Division 2, ATEX Zone 0
ATEXZone 2 and includes
ABSmaritime approval
Thermocouple Heat Sensor Cable
Thermocouple Type:Type J, K, T, or other
Voltage Rating:300V AC/DC (typical)
Conductor Gauge:20 AWG to 24 AWG
Jacket Material:High-temp PVC
Recip Rod Position Monitor
Signal :Accepts from 1 to 4 proximityprobe signals
InputImpedance:10 kΩ
Peak-Peak filter Fixed:1 Hz to 600 Hz
Gap filter: -3 dB at 0.09 Hz
Average pistonposition Fixed:1 Hz to 600 Hz
Average Gap:-3 dB at 0.09 Hz
3300 XL 25 mm Proximity Probe
02 M30x2 thread
MinimumUnthreadedLength0 mm
MinimumUnthreadedLength 70 mm
90 9.0 metres (29.5 feet)
00 No Armor
05 Multiple Approvals
Proximitor Sensor
3300 XL NSv Proximitor Sensor
71 7.0 meters (23.0 feet) systemlength
DIN mount
00 Not required
VibrationMonitors
DC Input 18~36 Vdc, max 7.5 W
Configurable Bandpass filter 0.2 Hz to 20 kHz
Scale Factorrange 5 to 1000 mV/g
Full scale range 2 to 80 g peak
Current Sink Source 3.3 mA ± 5%
Open Circuit Voltage -21 to -24 Vdc
3300 XL 8 mm Proximity Probes
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 80 mm
Minimum case length: 140 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 CSA, ATEX, IECEx Approvals
3300 XL 8 mm Proximity Probes
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 0 mm
Minimum case length: 50 mm
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 CSA, ATEX, IECEx Approvals
Fan monitor
Frequency Range:10 Hz to 1 kHz
Alarm Outputs:2x programmable
Accuracy:±1% of full scale
Power Supply:90-250V AC
Power Consumption:≤15W
Output Signals:4-20mA
Isolation:1500V AC input/output
3300 XL 8 mm Proximity Probes
330104 3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 80 mm
Minimum case length: 160 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
3300 XL Standard Extension Cable
3301300700005
EXTENSION CORD
070 7.0 meters (22.9 feet)
00 Standard cable
05 CSA, ATEX, IECEx Approvals
3300 XL 8 mm Probe
3300 XL Standard Extension Cable
045 4.5 meters (14.8 feet)
03 Armored cable with connectorprotector
00 Not required
Velomitor XA Piezo-Velocity Sensor
Sensitivity:3.94mV/mm/s (100 mV/in/s)±5%
VelocityRange:1270 mm/s (50 in/s) peak
Transverse Sensitivity:Less than 5% of sensitivity
Amplitude Linearity:±2% to 152 mm/s (6 in/s) peak
MountingTorque:45 N-m (33 ft-lb) maximum
3300 XL 8 mm Proximity Probes
Unthreaded Length Option : 00 = 0 mm
Overall Case Length Option : 02 = 20mm
Total Length Option : 10 = 1.0 metre (3.3 feet)
Connector and Cable-Type Option : 02 = Miniature coaxial ClickLocTM connector, standard cable
Agency Approval Option : 00 = Not required
Probe Tip Material: Polyphenylene sulfide (PPS).
Probe Case Material: AISI 303 or 304 stainless steel (SST)
3300 XL 11 mm Proximitor Sensor
51 5.0 meter (16.4 feet) systemlength
DIN mount
00 Not required

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.