A free rack slot is only the start. Before ordering a 3500 internal-barrier retrofit, check the earthing position, rear access and cabinet space against the installed layout.
Amikon Editorial Team · Published 16 November 2026 · Sources checked 16 November 2026
Record the installed rack model and mounting arrangement. Mark every front module and rear I/O position on the current layout, then draw the proposed layout with IS earthing and new barrier I/O.
In a standard full-size 19-inch rack, the dedicated IS earthing position leaves 13 positions for monitors. That is a capacity figure, not a count of empty slots. The mini-rack has seven positions and needs its own layout check.
If a standard I/O module or IS earthing module is between two internal-barrier I/O modules, the 3500/04 data sheet calls for at least two rack positions to access that intervening module. The rule applies to this arrangement; it does not mean every rack needs two empty slots.
The data sheet excludes External Termination for internal-barrier I/O. Monitors with TMR rack options cannot use these I/O modules. Show any such equipment on the layout for engineering review before specifying a replacement.
The 3500/04 data sheet says the standard rack with internal barriers will not fit a 400 mm cabinet. It describes approximately 50 mm of additional rack depth for separation of hazardous-area and safe-area wiring.
These values describe one dimension on the full-size rack/panel-mount drawing. They are not minimum clear cabinet depths.
Match the drawing to the mounting arrangement, then measure the cabinet around doors, rails, terminals, cable routes and rear maintenance access. The 3500/04 guidance places hazardous-area wiring above the rack and safe-area wiring below it.
Compare the proposed layout with the installed rack and measured cabinet. For each item, record the result or assign it to the responsible engineer for review.
Use the rack nameplate and current and proposed front/rear module maps. Confirm where the IS earthing module and new I/O will sit.
Check adjacent I/O modules, cabinet bulkheads and the maintenance route. Confirm whether the proposed placement meets the applicable access rule.
Use the applicable rack drawing and actual usable cabinet measurements. Confirm space for the rack, field wiring and maintenance access.
Review termination, TMR and project intrinsically safe design documents. Confirm which approvals still need engineering sign-off.
Mechanical fit does not establish approval of the intrinsically safe system.
Amikon lists a 3500/04-related product ↗ and a 3500/05 rack ↗. Use the product pages as starting points; confirm the exact supplied parts against the project layout.
Have the proposed layout checked against the project drawings before approving the order.


Need an automation or control part quickly?
Copyright Notice © 2004-2026 AMIKON is operated by Amikon Limited. Amikong.com is the company's official website and primary domain.
Disclaimer: Amikon Limited is an independent supplier and is not authorized by or affiliated with any manufacturer. Products may have older date codes, and AMIKON provides its own limited warranty. Original manufacturer warranties and manufacturer support are not provided. Firmware is not guaranteed; customers are responsible for obtaining any required firmware or licenses and complying with applicable End-User License Agreements.
Cookies
Individual privacy preferences
We use cookies and similar technologies on our website and process your personal data (e.g. IP address), for example, to personalize content and ads, to integrate media from third-party providers or to analyze traffic on our website. Data processing may also happen as a result of cookies being set. We share this data with third parties that we name in the privacy settings.
The data processing may take place with your consent or on the basis of a legitimate interest, which you can object to in the privacy settings. You have the right not to consent and to change or revoke your consent at a later time. This revocation takes effect immediately but does not affect data already processed. For more information on the use of your data, please visit our privacy policy.
Below you will find an overview of all services used by this website. You can view detailed information about each service and agree to them individually or exercise your right to object.
You are under 14 years old? Then you cannot consent to optional services. Ask your parents or legal guardians to agree to these services with you.
Leave Your Comment