
























Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Relay Output Terminal Board
Product Type: Relay Output Terminal Board
Number of channels: 16
Relay Type: SPDT
Relay Contact Rating: 10A
Input Voltage Range: 12V, 24V
Number of Relay Channels: 4, 8
Relay Switching Current: Max 10A
Mounting Type: DIN rail
Output Resolution: 12-bit
Output Impedance: 10 Ohm
Analog outputs: 0-20 mA
FEEDBACK I/O PACK
POWER DISTRIBUTION SYSTEM
FEEDBACK I/O PACK
PDM DIAGNOSTICS TYPE
FOR MARK VIE
TURBINE CONTROL SYSTEMS
AMBIENT TEMPERATURE:
-30 TO 65 DEGREES C
I/O pack
CARD
INPUT/OUTPUT PACK
PROTECTION TYPE
FOR MARK VIE TURBINE CONTROL SYSTEM
2 ETHERNET PORTS
POWER SUPPLY
LOCAL PROCESSOR
DATA ACQUISITION BOARD
POWER CONNECT CARD
Input Voltage:+24V DC
Input Range:+18V to +30V DC
Output Voltage:+23.5V to +24.5V DC
Max Current Capacity:40A total
Per-Slot Current:5A max (fused)
Efficiency:>92% (at full load)
Ripple Noise:<100 mV pk-pk
SDCI DC Power Supply and Instrumentation Board
DS200SDCIG1AFB
DISCONTINUED BY MANUFACTURER
P/S & INSTRUMENT BOARD
MULTI INPUT/ OUTPUT
ON BOARD RAM
NTB/3TB Terminal Board
531X305NTBAPG1
PC BOARD ASSEMBLY
ACDC2000
DRIVE TERMINAL
MARK V SERIES
DS200FSAAG2ABA
DISCONTINUED BY MANUFACTURER
GATE FIRING BD
MARK 5
TURBINE CONTROL
MULTI INPUT/ OUTPUT
ON BOARD RAM
INPUT TERMINATION BOARD
DS200TBQBG1ACB
DISCONTINUED BY MANUFACTURER
PC BOARD SDCC MARK V SYSTEM
TERMINAL BOARD R-S-T ANALOG 78WAY
Excitation Amplifier Module
IS200EXAMG1AAB
EX2100
Excitation Amplifier Module
Bridge and Protection Module
Exciter PT/CT Board
IS200EPCTG1AAA
Mark VI
EX2100 series
0-10 V or 4-20 mA
Input/Output Terminal Board
AE Bridge Interface Card
IS210AEBIH1BED
Mark VIe Series
Bridge Interface Card
AEBI CARD GE WIND TURBINE
Discrete Input/Output Module
Number of input channels: 24
Input Filter: Hardware filter, 4 ms
Input Signal Logic: Active High / Active Low
Input isolation in pack: 1500 V
Input Voltage Range: 5V DC / 24V DC
Ac voltage rejection: 60 V RMS
Isolation: Optical or Galvanic Isolation
Output Voltage Range: 5V DC – 250V AC
Contact Rating (Relay Output): 5A
ANALOG INPUT/OUTPUT MODULE
ANALOG INPUT/OUTPUT MODULE
I/O PACK
FOR A GE SPEEDTRONIC MKVIE
GAS TURBINE CONTROL
Ambient Temperature Range:-40 to 158°F
Analog Transmitter Power:22.8 VDC
THERMOCOUPLE INPUT UNIT
THERMOCOUPLE INPUT UNIT
MARK VIE
I/O PACK
POWER SUPPLY / 0.16 AMP / 28 VDC
FOR SPEEDTRONIC MKVIE GAS TURBINE CONTROL
INPUT MODULE
INPUT MODULE
I/O PACK / MARK VIE
MARK VI SERIES
SPEEDTRONIC GAS TURBINE CONTROL
24 DISCRETE INPUT
POWER SUPPLY / 0.24 AMP DC / 28 VDC
DISCRETE OUTPUT
IS220PDOAH1A
DISCONTINUED BY MANUFACTURER
I/O MODULE
Number of Channels: 24
Inputs: 125 V dc, 15A
Input Impedance: 4-20 mA
Input Converter Resolution: 16-bit A/D Converter
Product Type: Proportional Digital Output Module
Output Fuses 12 fuses: 250 Volt, 15 A
PAOC Analog Output Module
Mark VIe
Analog Output Module
Eight current output channels
0-20 mA, up to 900 Ohms
±0.5% over -30º to 65ºC
Excitation Control Board
IS200EMIOH1A
IS200EMIOH1AFB
PC BOARD
Excitation Control Board
Dc Input Power Supply
DS200TCPSG1APE
DISCONTINUED BY MANUFACTURER
POWER SUPPLY CONTROL CARD
PC BOARD SDCC MARK V SYSTEM
POWER SUPPLY BOARD
Acoustic Monitoring Terminal Board
IS200TAMBH1A
ACOUSTIC MONITORING TERMINAL BOARD
MARK VI
ACOUSTIC MONITORING CARD ASSEM
IS215VAMBH1A
DISCONTINUED BY MANUFACTURER
MONITORING CARD ASSEMBLY ACCOUSTIC

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.