













Power Supply XLS 480 W Power Supply
Part Number:1606-XLS480E
Input Voltage:100…240V AC / 110...150V DC
Terminals Spring:Clamp
Output Power:480 W
Signal:DC-OK
Output Current:20 A (@ 24V) /17 A (@ 28V)
POWER SUPPLY MODULE
POWER SUPPLY MODULE
220-240 VAC INPUT
50/60 HZ
1.3 AMP INPUT
5.1 VDC / 7.8 AMP OUTPUT
24 VDC / 1.7 AMP OUTPUT
Analog Input Module
SIMATIC S7-200 SMART
Analog input
SM AR02 RTD
2x AI RTDmodules
SM AR02, AI RTD 2x16 bit
24 V DC Yes; -15 / +20 %
Current consumption, typ. 40 mA
from backplane bus 5 V DC, typ. 80 mA
Power loss, typ. 1.5 W
88TK05 Station- Bus Coupler Module
Supply Voltage:24V DC (±15%)
Power Consumption:1.8W (typical)
Interface:9-pin D-Sub
Bus Termination:Integrated
Bus Protocol:PROFIBUS DP (EN 50170)
Transmission Rate:9.6Kbps to 12Mbps
Address Range:0-125
Max Number of Slaves:125
Electrical Isolation:500V AC
Redundant fault-tolerant control system
Input Voltage: 24V DC
Current Consumption: 1.5A typical
Isolation: 1500V AC channel-to-channel
Trip Contact Ratings:5A @ 30V DC resistive
Analog Inputs: 8 channels
Relay Outputs: 8 channels
Communication Ports: 2x Ethernet for diagnostics
Resistance Temperature Device
RTD INPUT MODULE
8 CHANNEL
14-BIT
15 OHMS MAX.
2 ETHERNET PORTS
FOR MARK VI TURBINE CONTROL SYSTEM
Thermocouple Input Module
IO PACK
THERMOCOUPLE
2 ETHERNET PORTS
AMBIENT TEMPERATURE RATING:
-30 TO + 65°C (-22 TO +149 °F)
Discrete Contact Input I/O Module
Power Supply:28VDC
Functional Revision 1:A
Mark VI Series Grouping:Group 1
Number of Channels:16 (isolated)
Input Type:Dry contact (volt-free) or wet contact (24–125V DC)
Voltage Range:24–125V DC (configurable)
Input Current :2–20mA per channel
On-State Voltage:≤3V DC (for dry contact)
Off-State Leakage:<1mA
Analog I/O Module
CARD
INPUT/OUTPUT PACK
ANALOG IN/OUT
200 MA TYPE
FOR MARK VIE TURBINE CONTROL SYSTEM

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.