
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
BINARY OUTPUT MODULE
BINARY OUTPUT MODULE
Testable relay output module
32 OUTPUTS
100 MA PER OUTPUT
NON-ISOLATED
MODULE FUM 210
TELEPERM XP MODULE FUM 210
BINARY TRANSMITTER SIGNAL CONDITTONING
AND DRIVE CONTROLLER MODULE BINARY TRANSM.
SIGNAL CONDITTONING - 24DC
TRANSMITTER SUPPLY -TRANSM.
MONITORING F. WIRE BREAK
SHORT CIRCUIT TO M
SHORT CIRCUIT TO P
INTERCORE SHORE CIRCUIT
INTERFACE MODULE
TELEPERM XP INTERFACE MODULE IM308C
INTERFACE MODULE LOCATED IN THE AP OR EG FOR
THE CONNECTION BETWEEN AP AND ET200
INTELLIGENT FIELD DEVICES,
FOR THE SUPPORT OF
THE CENTRALIZED ENGINEERING OF
THE INTELLIGENT FIELD DEVICES
SENSOR CONDITIONING
TELEPERM XP MODULE FUM 210
FOR SENSOR CONDITIONING FAST BINARY SIGNAL ACQUISITION,
OR DRIVE CONTROL SENSOR, MONITORING AND SIGNAL.
MODULE CONDITIONING:
14 CHANGEOVER OR 28 SINGLE CONTACTS
WITH SENSOR SUPPLY AND MONITORING,
28 BINARY INPUTS WITHOUT SENSOR SUPPLY
BINARY SIGNAL COUPLING MODULE
TELEPERM XP MODULE FUM 211,
BINARY SIGNAL COUPLING MODULE
16 BINARY INPUTS
WITE ELECTRICAL ISOLATION
VIA OCTOCOUPLERS 16 BINARY
OUTPUTS 250 MA (WITH LIMITATION)
STEADY OR FLASHING (8, 2, 0,5 HZ)
SUITABLE TO CONNECT CONSOLE CONTROL TILES.
CAPABLE FOR 2 DESK TILES USE IN SPPA-T200
SENSOR CONDITIONING
TELEPERM XP MODULE FUM 210
SENSOR CONDITIONING
FAST BINARY SIGNAL ACQUISITION
OR DRIVE CONTROL SENSOR,
MONITORING AND SIGNAL
MODULE CONDITIONING:
14 CHANGEOVER
28 SINGLE CONTACTS
WITH SENSOR SUPPLY AND MONITORING
28 BINARY INPUTS
WITHOUT SENSOR SUPPLY
I/O Bus Comparator And Switchover Module
6DS11448AA
DISCONTINUED BY MANUFACTURER
I/O BUS COMPARATOR & SWITCHOVER MODULE
MS Point Extention
MEASURING POINT EXTENSION MODULE
I/O MODULE
14 CHANNEL
FOR THERMOCOUPLES
FOR PT100 RESISTANCE THERMOMETERS
FUM 232 Analog Module
FUM 232 MODULE
ANALOG TRANSMITTER
SIGNAL CONDITIONING MODULE
FOR PT100 AND THERMOCOUPLE
TRANSMITTER SIGNAL CONDITIONING
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.