ABB are a market leading producer of power & automation technologies that enhance performance and reduce environmental impact for industries worldwide.
Amikon Limited stock and supply ABB motors, drives, programmable logic controllers (PLCs), power electronics and Robot spare parts and Discontinued card parts, motion and obsolete including variable speed drives, DC drives, PLCs and general automation spares.
ABB are a market leading producer of power & automation technologies that enhance performance and reduce environmental impact for industries worldwide.
Amikon Limited stock and supply ABB motors, drives, programmable logic controllers (PLCs), power electronics and Robot spare parts and Discontinued card parts, motion and obsolete including variable speed drives, DC drives, PLCs and general automation spares.
Number of Channels: 16 connection points
Isolation: 250V AC
Rated Voltage: 250V AC/DC
Current Rating: 2A per channel
Contact Resistance: <50mΩ
Insulation Resistance: >100MΩ @ 500V DC
Dielectric Strength: 2000V AC (50Hz)
Frequency range: 1Hz-20kHz
Input sensitivity: 50mV RMS minimum
Isolation: 1500V AC between channels
Analog Inputs:4-20mA position
Control Outputs: 4-20mA governor control signal
Power Supply:24VDC nominal
Accuracy: ±0.1% of reading ±1 RPM
DC Bus Monitoring:0–1000V DC typical
Logic Side: +24V DC (±10%)
Gate Drive Side: +15V/-8V
Current Consumption:<500mA
Gate Drive: Peak 2A
Reinforced Isolation: 2500V AC
Working Voltage: 1000V DC
Input Current Range:±10A (direct input)
Output Signal:4-20mA analog output
Analog Output: 4-20mA (load ≤500Ω)
Accuracy: ±0.5% of full scale
Bandwidth: 10kHz (-3dB point)
Isolation Voltage: 2500V AC
Input Voltage: 24V DC
Power Consumption: ≤1.5W
Isolation: 500V AC
Signal Conditioning:16-bit ADC resolution
Analog Input:4-20mA + HART
4-20mA loop drive: ≤500Ω
Communication Speed: 1200 bps (FSK)
Multidrop Mode: Supports up to 15 devices
Magnetic pickup (MPU) or proximity probe
Frequency range: 1Hz to 10kHz
Input sensitivity: 50mV RMS minimum
Accuracy: ±0.1% of reading ±1 RPM
Analog Output:4-20mA
Load capacity: ≤500Ω
Power Supply:24V DC ±10% (standard)
Input Voltage:24V DC
Output Voltages:+24V DC
Current Capacity:+24V: 2A max
Efficiency:≥85% (full load)
Ripple Noise:<1% of output voltage
Reinforced Isolation :1500V AC input-to-output)
Processor:Dual-core ARM Cortex
Memory:2GB RAM
I/O Capacity:Supports up to 512 I/O points
Power Supply:24V DC
Power Consumption:≤15W (typical)
Ethernet: 2× 10/100/1000 Mbps
Fieldbus: PROFIBUS DP, Modbus TCP/RTU
Number of Phases:3-phase
Degree of Protection:IP21
Enclosure Type NEMA:Type1
Altitude:1000 m
Operating Humidity (RHamb):5 ... 95
Sound dB (A):63 dB(A)
Frequency (f):47.5 ... 63 Hz
Frame Size:R5
Input Voltage (Uin):380 ... 480 V
Input Voltage:24V DC ±10%
Gate Drive Output:+15V/-8V (typical for IGBTs)
Isolation Voltage:2500V AC
Current Sensing Accuracy:±1% of full scale
Switching Frequency:Up to 20kHz
Fiber optic for control signals
Terminal blocks for power connections
Multi-pin headers for auxiliary signals
Emitter Voltage:1700V
Collector Current: 300A @ 80°C
Pulsed Current : Up to 600A
Switching Frequency: Up to 20kHz
Low Saturation Voltage:2.0V
Isolation Voltage: 2500V AC (min)
Supply Voltage: 24V DC (±10%)
Power Consumption: <5W (typical)
Operating Current: 200mA @ 24V DC
Communication Speed: Up to 12Mbps
Optical: ST or BFOC type
Electrical: Terminal block or D-sub
24 binary outputs with enclosed relays (NO contacts)
Current carrying capacity of the relays: max. 1 A
Channel-by-channel isolation of the outputs
Module is capable of redundant operation
Monitoring of the module
Counter for switching cycles (channel by channel)
