
RAM Charger Module
Optional C300 Memory Backup
Series 8 C300 RAM Charger Module
Support up to 4 C300 controllers in one module
Supports redundant power supply inputs through combo cable
Supports Experion soft failure alarm for RAM charger battery status
Typically mounted adjacent to its associated C300 IOTA(s)
3300 NSv Proximity Probes
330901 3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 1.1 in
Minimum case length: 2.5 in
10 1.0 meter (39 in)
01Miniature coaxial ClickLoc connector
with connector protector, standardcable
Governor Detection Board
Frequency range: 1Hz-20kHz
Input sensitivity: 50mV RMS minimum
Isolation: 1500V AC between channels
Analog Inputs:4-20mA position
Control Outputs: 4-20mA governor control signal
Power Supply:24VDC nominal
Accuracy: ±0.1% of reading ±1 RPM
TEACH PENDANT MAINBOARD
Operating Voltage: 24V DC
Power Consumption: <15W
Isolation: Opto-isolated I/O for safety signals
CPU: ARM-based microcontroller
Flash Memory: Stores firmware and configuration
3300 XL 25 mm Proximity Probe
06 M39x1.5 thread
Minimum Unthreaded Length 0 mm
Minimum Unthreaded Length 0.7 in
10 1.0 metre (3.3 feet)
00 No Armor
05 Multiple Approvals
Double Motor Module
SINAMICS S120
Double Motor Module
input: 600 V DC
output: 400 V 3 AC, 9 A/9 A
type of construction: booksize internal
air cooling optimized pulse patterns
and support of the extended Safety
Integrated functions
incl. DRIVE-CLiQ cable
3300 XL 25 mm Proximity Probe
Minimum Unthreaded Length 0 mm
Maximum Unthreaded Length 0.7 in
10 1.0 metre (3.3 feet)
00 No Armor
05 Multiple Approvals
3300 XL 11 mm Proximity Probes
330703 3300 XL 11 mm Probe
M14 x 1.5 thread,without armor
Minimum unthreaded length:60 mm
Minimum length:80 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
Touchscreen panels
State-of-the-art graphics
Robust and reliable
Truly open platform
Display type:Touch
Display size 15.4"
Brightness:450 cd/m²
Display resolution, ratio:1280 x 800 (16:10)
Processor:ARM9 (1 GHz)
Main memory:1 GB
3300 5mm Proximity Probes
330171 3300 5mm Probe
1/4-28 UNFthread, without armor
0 0 = 0.0 in.
Minimum unthreaded length: 12 = 1.2 in
5 0 5.0 metres (16.4 feet)
0 1Miniature coaxial ClickLocconnector
with connectorprotector, standard cable
Power Control drive board
DC Bus Monitoring:0–1000V DC typical
Logic Side: +24V DC (±10%)
Gate Drive Side: +15V/-8V
Current Consumption:<500mA
Gate Drive: Peak 2A
Reinforced Isolation: 2500V AC
Working Voltage: 1000V DC
Communications Gateway
Two separate Ethernet ports
allow each protocol to reside on separate subnets
Multiple I/O connections
Includes an embedded EDS Add-On Profile
reduced commissioning time
Gateway includes a SD card slot
Secure module configuration via module switch
Up to 10,000 16-bit registers
3300 NSv Proximity Probes
330901 3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 1.0 in
Minimum case length: 2.5 in
10 1.0 meter (39 in)
01Miniature coaxial ClickLoc connector
with connector protector, standardcable
00 Not required
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.