ALL MANUFACTURERS

Digital Input Module

Input Channels: 16 or 32 channels
Isolation: 500V
Input Voltage Range: 24V DC
Input Current: Typically 3-5mA 
On-State Voltage: 15-30V DC
Off-State Voltage: 0-5V DC
Response Time: <1ms (typical)
Input Impedance: ~3kΩ (typical)

Micromaster 440

Power Module

Digital I/O Module

Number of outputs 16-channel, module isolation
Output voltage 24 V DC
Output voltage drop 1 V maximum
External power supply rating 24 V DC, 3.4 A minimum
Maximum leak current at output off status 1.6 mA
Output format Current source
Minimum load current 35 mA
Load resistance range 120 to 685 Ω
Output response time 30 ms maximum

SITOP PSU8200 Power Supply

SITOP PSU8200 
24 V/20 ASITOP PSU8200 
24 V/20 A STABILIZED POWER SUPPLY 
INPUT:3 400-500 V AC 
OUTPUT: 24 V/20 A DC

Binary output module

24 binary outputs with enclosed relays (NO contacts)
Current carrying capacity of the relays: max. 1 A
Channel-by-channel isolation of the outputs
Module is capable of redundant operation
Monitoring of the module
Counter for switching cycles (channel by channel)

Combined overcurrentand earth-fault relay

Rated Current (I_n): 1 A or 5 A
Current Input: ≤ 0.1 VA
Frequency Range: 45–65 Hz
Binary Inputs: 5 (24–250 V DC/AC)
LED Indicators: 9 (Trip, Start, Alarm, Ready, etc.)
Operating Temperature: -25°C to +55°C
Storage Temperature: -40°C to +70°C
Humidity: ≤ 95% RH (non-condensing)

Drive control unit

Supply Voltage: 24V DC (±10%)
Power Consumption: 15W typical
Isolation: 500V AC 
2x RJ45 Ethernet ports 
USB port for local configuration
8 digital inputs (24V DC)
4 digital outputs (24V DC, 0.5A)
2 analog inputs (±10V or 0/4-20mA)
2 analog outputs (0/4-20mA)

DDCS Branching Unit

Protocol: ABB DDCS 
Baud Rate: 12Mbps
Supply Voltage: 24V DC (±10%)
Power Consumption: 10W typical
Isolation: 500V AC
Fiber Type: Multi-mode 62.5/125μm

Submodule Carrier

Supply Voltage: 24V DC (±10%)
Power Consumption: 2W
Backplane Current: 1A maximum per slot
Isolation: 500V AC
System Connection: S800 bus to main controller
Field Connection: Screw terminals for I/O wiring
Bus Speed: 1.5Mbps 

3300 XL Standard Extension Cable

070 7.0 meters (22.9 feet)
00 Standard cable
05 CSA, ATEX, IECEx  Approvals

3300 XL Standard Extension Cable

045 4.5 meters (14.8 feet)
03 Armored cable with connectorprotector
00 Not required
3300 XL Standard Extension Cable

PC I/O BOARD

Number of Channels: 16 or 32 
Input Voltage: 24V DC
Isolation: 500V opto-isolation
Channels: 8 single-ended 
Input Range: 0–10V, ±10V

Velomitor XA Piezo-Velocity Sensor

0 1 CSA/NRTL/C
Velomitor XA Piezo-velocitySensor 
330525 Velomitor XA Piezo-velocitySensor

SIWAREX MS Weighing Module