














Power Supply Module
Input Voltage:85-264V AC (47-63Hz)
Output Voltage:24V DC ±1%
Output Current:10A continuous (12A peak for 5s)
Power Rating:240W
Efficiency:>92% @ 230V AC
Inrush Current:<25A @ 230V AC
Relay Output Base
PLC RELAY OUTPUT
BASE
Current: 2A to 5A
Voltage: Up to 250V AC/DC or 24V DC
AC: Up to 250V AC, 5A
DC: Up to 30V DC, 5A
Operating Temperature Range -10°C to 60°C
I/O INTERFACE CARRIER
I/O INTERFACE CARRIER
DELTA V
CARRIER SHIELD BAR
CARRIER EXTENSION CABLE
Universal Measurement Card
Input Signal andRaw Signal Voltage Range-1 V to -22 V
Frequency Range 0 to 18750 Hz
Supply Voltage -23.25 V / -26.0 V DC
Maximum Supply Load 35 mA
Supply Gain Accuracy ±3.5%
Supply Offset Accuracy +100 µA / -0 µA
Supply Voltage Reserve + 25 V
Supply Temperature Drift ±50 µA
KJ1501X1-BC3 System Power Supply
KJ1501X1BC3
DISCONTINUED BY MANUFACTURER
POWER SUPPLY SYSTEM
DUAL
DC/DC
INPUT
12 VDC
24 VDC
Tariff Code: 8504409520
Country of Origin: Philippines
Discrete Output Module
KJ3204X1BA1
DISCONTINUED BY MANUFACTURER
MODULE OUT CARD
32 CHANNEL
24VDC
(12P3275X042 VE4002S1T2B5)
KJ3222X1-BA1 Analog Input HART Module
KJ3222X1BA1
DISCONTINUED BY MANUFACTURER
INPUT MODULE
8POINT
ANALOG
4-20MA
HART
Tariff Code: 8538907080
Country of Origin: Malaysia
HART Analog Output Module (EM)
Number of channels 8
Channel Update Rate 24 mS
Output Range 4 to 20 mA
D/A Resolution 14 bits
Accuracy over Temperature Range 0.25% of Span
Output Loading 4-20mA into 700 ohm load Maximum
HART Analog Output Module (PM)
Number of channels 8
Channel Update Rate 24 mS
Output Range 4 to 20 mA
D/A Resolution 14 bits
Accuracy over Temperature Range 0.25% of Span

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.