-
Please try to be as accurate as possible with your search.
-
We can quote you on 1000s of specialist parts, even if they are not listed on our website.
-
We can't find any results for “”.
Sub-D to Knife terminals FTA
37-pole sub-D male connector
(CN1) that must be connected
with (16) RUSIO channelsl 16 sets
of two knife terminals for the sixteen channels
Each channel has a the following knife
terminal connections:l A+ terminal that is the (RUSIO)
signal connection.l A- terminal that is
the common 0 Volt connection.
Earth Fault Monitor
Temperature -40°C to +75°C
(-40°F to +167°F )
Approvals CE, TUV
DIN EN rails: TS32 / TS35 x 7.5
Input voltage:24 VDC +30/-15%
Input current:10 mA maximum 25 mA
Voltage typically +4.1 VDC
Resistor (R)approximately 2.8 kOhm
SM RIO 36 inch Carrier
Product Type : SM RIO 36 inch Carrier
Operating temperature : -40 .. +70 degC
Storage temperature : -40 .. +85 degC
Relative humidity : 10..95% (non condensing)
Pollution : Pollution degree 2 or better
Approvals : CE; UL pending
PWA / I/O LINK MODULE
Module Type I/O Link Module
Power Supply 24 VDC
Operating Temperature -20°C to +60°C
Storage Temperature -40°C to +85°C
Humidity 5% to 95% non-condensing
Enraf Vito LT Interface 762
An electronic converter used
in combination with the VITO probes
HART® communication to tank gauging ATG *2
ATEX KEMA 01ATEX1212
IECEx KEM 05.0014
Kosha certificate; 13-AV4BO-0487
FM I. D. 3015746
CSA certificate 1635480
Interface Board
TDC3000
TDC3000 framework
5 VDC
Approx. 1.5 W
300 mA (nominal)
TDC-specific protocols for
data transfer and communication
WSI2 Unix coprocessor card
100 MHz
without graphics
used in the UxS and AxM.
with 32, 64, or 128 MB of RAM memory
Turbo Peripheral DG – UxS
Power Requirements 24 VDC
Operating Temperature Range -20°C to 60°C
Humidity Range 5% to 95%
Mounting Options
Standard DIN rail or custom rack mounting
Operator Keyboard
Fully programmable customized menus
LCD color touchscreen, and buttons
Softkeys support different colors and text
Touch pad and touch ring
Ergonomic design with padded wrist rest
Variable-speed joystick with integral zoom control
L ocking power connector
Dedicated keys for commonly used functions
Dynamic menu selection
Web interface for configuration and firmware upgrades
Laser cut backlit keys
CIRCUIT BOARD
TDC 3000 systems
Input Voltage: 24 V DC (typical)
Power Consumption: ≤10W
Operating Temperature: -20°C to +70°C
Storage Temperature: -40°C to +85°C
Interface Converter Board
24V DC internal power supply
within the system
-20 ° C to 70 ° C
5% to 95%, no condensation
Multiple digital/analog input/output interfaces
DIN rail installation or rack mounted installation
Control Card
Voltage: 24 VDC (±10%)
Channel-to-Channel: 250 VAC minimum
Channel-to-Bus: 500 VAC reinforced isolation
Channels: 8 or 16
Resolution: 16-bit
Accuracy: ±0.1% of full scale
Operating Temperature: -40°C to +70°C (-40°F to +158°F)
Humidity: 0–95% RH, non-condensing
UCN Series Module
Output Frequency:50 kHz
Processing Capacity:High-speed data processing
Communication Protocol:Supports multiple industry-standard protocols
Operating Temperature:-40°C to +70°C
Memory Size:Extended memory capacity for enhanced system functionality
Power Supply
51198947100
DISCONTINUED BY MANUFACTURER
POWER SUPPLY
115/240 VAC INPUT
50/60 HZ
25 VDC OUTPUT
10 AMP LOAD
550 WATT POWER
Low Level Analog Mux Module
Manufacturer : Honeywell
Product No. : 51309218-125
Product type : Low Level Analog Input Multiplexer RTD FTA
Not CE compliant, not conformally coated
Redundancy not supported
Input channels : 16
Teminals : compression
LLMux RTD FTA with compression terminals
Single IOP interface
Digital Input Power Module
Pulse Input FTA - MC-TPIX52
CE compliant, conformally coated
Use with IOP MU-PPIX02 or MC-PPIX02
Redundancy not supported
Input Points - 8
Terminals - Screw
Size B - 12 inches (307 mm)
Analog Input Module
Low Level Multiplexer Thermocouple FTA - MC-TAMT13
CE compliant, conformally coated
Redundancy not supported
Input channels - 16
Teminals - compression
Size B - 12 inches (307 mm)
Purbo Peripheral Display Generator
Temp: 0°C to 50°C
Power: Standard Honeywell supply
Humidity: 5% - 90% RH
Refresh: Real-time
Type: DCS Display
MEMORY BOARD
Model: 51401072-300
Type: Memory Board
Function: Used in process control systems
System Compatibility: Honeywell TDC 3000 Process Control System
Operating Temperature Range: 0°C to 60°C (32°F to 140°F)
Processor Module
Model: 51403393-200
Operating Voltage: 24V DC
Power Consumption: Low power design
Operating Temperature: 0°C to +60°C
Storage Temperature: -40°C to+85°C
CPU Type: High performance embedded processor, specifically optimized for control systems
CONTROL BOARD
51401551201
CONTROL BOARD
PWA K2LCN 2MW
MULTI INPUT/OUTPUT
PANEL MOUNT
SINGLE SLOT
