


























Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Control Panel
Intel Core i5/i7 processor (generation varies)
RAM: 8-32GB DDR4
Storage: 256GB-1TB SSD
Power Supply:100-240V AC, 50/60Hz
Role-based access control
Audit trail logging
Cyber security compliant
LV AC general purpose wall-mounted drive
Number of Phases:3-phase
Degree of Protection:IP21
Enclosure Type NEMA:Type1
Altitude:1000 m
Operating Humidity (RHamb):5 ... 95
Sound dB (A):63 dB(A)
Frequency (f):47.5 ... 63 Hz
Frame Size:R5
Input Voltage (Uin):380 ... 480 V
IGBT MODULE
Emitter Voltage:1700V
Collector Current: 300A @ 80°C
Pulsed Current : Up to 600A
Switching Frequency: Up to 20kHz
Low Saturation Voltage:2.0V
Isolation Voltage: 2500V AC (min)
DDCS Communication Option Module
Supply Voltage: 24V DC (±10%)
Power Consumption: <5W (typical)
Operating Current: 200mA @ 24V DC
Communication Speed: Up to 12Mbps
Optical: ST or BFOC type
Electrical: Terminal block or D-sub
Drive control unit
Supply Voltage: 24V DC (±10%)
Power Consumption: 15W typical
Isolation: 500V AC
2x RJ45 Ethernet ports
USB port for local configuration
8 digital inputs (24V DC)
4 digital outputs (24V DC, 0.5A)
2 analog inputs (±10V or 0/4-20mA)
2 analog outputs (0/4-20mA)
DDCS Branching Unit
Protocol: ABB DDCS
Baud Rate: 12Mbps
Supply Voltage: 24V DC (±10%)
Power Consumption: 10W typical
Isolation: 500V AC
Fiber Type: Multi-mode 62.5/125μm
PC I/O BOARD
Number of Channels: 16 or 32
Input Voltage: 24V DC
Isolation: 500V opto-isolation
Channels: 8 single-ended
Input Range: 0–10V, ±10V
Power Board
Input Voltage:24V DC nominal
Output Voltage:+5V DC (±1%)
Current Capacity:10A (50W)
Total Power: 170W maximum
Efficiency: >85% at full load
Ripple Noise: <50mV p-p
Reverse polarity protection
Overvoltage protection (35V DC max)
Inrush current limiting
IGCT MODULE
Voltage Rating:4500V (VCES)
Current Rating:4000A (IT(RMS))
Max. Turn-off Current:6000A (ITGQM)
On-State Voltage Drop:1.85V (typical @ 4kA)
Switching Frequency:Up to 500Hz
Gate Driver Voltage:±20V (isolated)
16 Bit Profibus DP Adapter Module
Up to 12 Mbps.
Auto-detection of baud rate
Address Range: Configurable from 0 to 126
Supply Voltage: 24 VDC ±10%.
Power Consumption: < 2 W
Operating Temperature: -10°C to +55°C.
Storage Temperature: -40°C to +70°C
Power Interface Module
Voltage: 125 VDC Nominal
Power Consumption: Typically < 5W
Input-to-Input: 1500 VAC min.
Input-to-Output/Logic: 1500 VAC min.
Output-to-Output: 500 VAC min.
Output/Logic-to-S+ I/O: 500 VAC min
Gate Circuit Board
DRIVE
IGBT
BOARD KIT
Modbus TCP/IP
-20°C to 60°C (-4°F to 140°F)
Number of Inputs: 16
Number of Outputs: 16
DC drive motherboard
Memory:32MB SDRAM
Control Loop Time:100μs (speed)
Digital I/O:12x 24V DC inputs
Supply Voltage:24V DC ±10%
Power Consumption:15W max
Isolation :2500V AC
Main Control Circuit Board
PROFIBUS DP
PROFINET
Modbus RTU/TCP
Ethernet/IP
Clock Speed: ≥200 MHz
Supply Voltage: 24 VDC (±10%)
Power Consumption: Typically <15W
Power drive board
Input Voltage: 3-phase, 380-480V AC
Output Current: Up to 30A
Switching Frequency: 2-16 kHz
Power Board
Input Voltage:24V DC (±10%) or 115/230V AC
Output Voltages:+5V, ±15V, +24V DC
Power Capacity:100W (max)
Inrush Current:15A (for 20ms at 230V AC)
Efficiency:>90% (at full load)
Fiber-Optic Signal Isolation :2500V AC
Drive power board
Input Voltage:3-phase 380-480V AC (±10%)
Output Voltages:+24V DC (control)
Power Capacity:500W (continuous)
Switching Frequency:20kHz (PWM)
Efficiency:>92% (at full load)
Interface Board
Input Voltage:24V DC (±10%)
Power Consumption:8W (typical)
Isolation Voltage:1500V AC (channel-to-channel)
Communication Speed:Up to 1Mbps
Signal Channels:16 digital I/O
Circuit Board
Operating Voltage:24V DC (±10%)
Power Consumption:2W (typical)
Signal Range:0–24V DC, 4–20mA
Resolution:12–16-bit
Short-Circuit Protection:Self-resetting fuse
Control panel
ACS580 CONTROL PANEL
Assistant control panel
Protection Class:IP54 (Front Panel)
MTBF:>150,000 hours
Display Type:LCD (Backlit)
Resolution:128 x 64 Pixels
Languages:Multi-language support
Keypad:Membrane/Sealed (Dustproof)
Inverter Circuit Board
Model Number:AGPS21C (64668064)
Type:SACS800 Inverter Circuit Board
Input Voltage Range:85-264V AC (47-63Hz)
Output Voltage:24V DC (±1%)
Output Current:5A (continuous)
Power Rating:120W
Efficiency:>88%
Inrush Current:<30A (at 230V AC)
Inverter Memory Card
Memory Type:Flash EEPROM
Storage Capacity:2MB
Write Cycles:100,000 cycles
Interface:Proprietary ABB connector
Operating Voltage:3.3V DC (supplied by drive)
Power Consumption:<50mA
ESD Protection:±8kV contact discharge
CHOPPER CONTROL BOARD
Model Number:NBRC-61C (61357246F)
Type:Chopper Control Board
Operating Voltage:24V DC (±10%)
Power Consumption:8W (typical)
Signal Levels:0-10V analog, 24V digital
Isolation Voltage:1500V AC (input-to-output)
PWM Frequency:2kHz (adjustable)
Current Regulation:±1% of setpoint
Response Time:<5ms (90% step change)
Resolution:12-bit (analog signals)
CONTROL UNIT
CONTROL UNIT
DRIVE CONTROL ASSEMBLY
SCREW CLAMP TERMINALS
WITH COMMS ADAPTER PORT
(3AUA0000036521)
IGCT Module
Blocking Voltage : 4500V
Maximum Repetitive Off-State Voltage:4500V
Gate Trigger Voltage (VGT): 1.5V–2.5V
Peak Surge Current (ITSM): 25–30kA
Critical Rate of Current Rise (di/dt): 1kA/µs
Turn-On Time (ton): <5µs
Turn-Off Time (toff): <10µs
Switching Frequency: Up to 500Hz

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.