ALL MANUFACTURERS

INTERCONNECTOR

Contact Configuration:96-position (48x2 rows)
Contact Material:Gold-plated copper alloy
Current Rating:1A per contact (max)
Voltage Rating:60V DC max
Contact Resistance:<20mΩ (initial)
Insulation Resistance:>100MΩ @500V DC
Mating Cycles: >500 insertions

Industrial Control Board

Supply Voltage:24V DC ±10%
Power Consumption:15W (max)
Isolation Voltage:1500V AC (I/O to logic)
ESD Protection:±8kV (contact discharge)
Processor: 32-bit RISC-based
Memory: 16MB Flash,
I/O Capabilities:8x digital inputs (24V DC)

Industrial Control Board

Supply Voltage:24V DC ±10%
Power Consumption:20W (typical)
Processor:32-bit DSP (200MHz)
Memory:16MB Flash, 8MB RAM
Isolation Voltage:1500V AC (I/O to logic)

Advanced Control Module

Processor:Dual-core PowerPC @ 1.2GHz
Memory:2GB DDR3 RAM + 4GB Flash
Control Loops:Up to 256 PID loops
Scan Time:0.1ms (minimum)
Task Capacity:32 parallel tasks
Legacy Protocols: PROFIBUS-DP
Max Expandable I/O: 1024 points
High-speed analog:±10V/4-20mA

Communication Interface Module

Supply Voltage:24V DC ±10%
Power Consumption:8W (typical), 12W (max)
Isolation:2500V AC (port-to-port)
ESD Protection:±8kV (contact discharge)
Ethernet Ports:2x 10/100BASE-TX (RJ45)
Serial Interfaces:2x RS-485 (isolated)
Protocol Support:PROFIBUS DP-V1
Data Rate:Up to 12Mbps

Control Module

Supply Voltage:24V DC ±10%
Power Consumption:15W (typical), 25W (max)
Isolation Voltage:1500V AC 
ESD Protection:±8kV 
Control Loops: Up to 512 PID loops
Execution Time: 0.1ms for basic instructions
Task Capacity: 64 parallel tasks
Memory Cycle Time: <10ns

Current Voltage Input Module

Pulse Amplification Board

Input Voltage Range:10mV - 30V AC/DC
Input Impedance:100kΩ (typical)
Output Signal:24V transistor / 0-20mA
Output Current:≤500mA (transistor), ≤20mA (analog)
Isolation Voltage:1500V AC 
High-gain amplifier: 10-100x adjustable
Wide input range: 10mV to 30V pulses
Frequency response: DC to 500kHz
Isolated output: 24V PNP/NPN or 0-20mA

Procontrol System Coupling Module

Voltage: 24 VDC (±15%) or 110–240 VAC
Power Consumption: 5–10 W
Operating Temperature: -20°C to +60°C.
Humidity: 5–95% non-condensing.

Control Board

Analog I/O update rate: 1 kHz
Digital I/O update rate: 10 ms
Standard range: -20°C to +60°C
Extended range: -40°C to +70°C 
Power consumption: Max. 10W
Humidity: 5% to 95% RH
16-bit resolution for analog inputs/outputs