ALL MANUFACTURERS

Part Number IC695ETM001
Specialty ModuleRX3i Ethernet module 
10/100 Mbits 2 RJ45 connections one IP 
address occupies one slot on system base
Current Consumption
840 mA @ 3.3 VDC; 614 mA @ 5 VDC
Operational NotesUniversal Backplane Only. 
Uses PCI Bus. Client/Server

Remote DIGITAL OUTPUT MODULE

Number of Channels: 8 digital output channels
Output Voltage Range: 24 VDC ± 20%
Output Current: Maximum 1 A per channel
Power Supply Voltage: 24 VDC
Communication Interface: 
Dual RBUS for high-speed data transfer

Remote Multi-Purpose Input/Output Module

Input supply voltage: 24 VDC (18-31.2 V)
Loop voltage: Input supply voltage
Input loop current: Max. 4 mA @ 24 VDC 
loopvoltageChannel "Off" current: <0.5 mA
Channel "On" current: >3 mA
Max input voltage: Input supply voltage
Max. input signal freq.: 10 ms pulse
Compliance: Namur comp 

BUS MODULE

Power Supply Voltage: 
10 to 28.8 VDC from SPBus
Operational Temperature Range: -15°C to +70°C
Storage Temperature Range: -25°C to +70°C
Relative Humidity: Up to 98%

Remote DigitalInput/Output and relay

Input supply voltage: 24 VDC (18-31.2 V)
Loop voltage: Input supply voltage
Input loop current: Max. 4 mA @ 24 VDC loopvoltage
Channel "Off" current: < 0.5 mA
Channel "On" current: > 3 mA
Max. input voltage: Input supply voltage
Max. input signalfreq.: 10 ms pulses

Remote Analogue Input, Current

Number of channels: 32 current inputs
Current input: 0-20 mA (input resistor 220 ohm)
Current accuracy: +/- 0.2% of full scale
(resistor accuracy = 0.1%)
Current input lter: RC = 33 µs
Digital resolution: 12 bits
Connectors: screw terminals, 2.5 mm

Remote Digital Input and Output

Input voltage: 24 VDC ±20%
Power consumption: maximum 20 W
Connectors: screw terminals, 1.5 mm
operational: 0° C to 70° C
storage: -25° C to 70° C
Power supply voltage: 10 to 28.8 VDC
SPBus connector: 9-pin male DSUB

Remote Controller Unit

Input voltage: 24 VDC ±20%
Power consumption: maximum 20 W
Connectors: screw terminals, 1.5 mm
operational: 0° C to 70° C
storage: -25° C to 70° C
Power supply voltage: 10 to 28.8 VDC
SPBus connector: 9-pin male DSUB

Remote Controller Unit

Input supply voltage: 24 VDC(+30%, -25%)
Nominal current consumption: ≈ 0.8 A
Start-up current: Max. 2.7 A
Power consumption: Max. 20 W
Heat dissipation: Max. 20 W

Remote Controller Unit

REMOTE CONTROLLER UNIT
32 I/O CHANNELS
32-BIT CPU RUNNING AT 400 MHZ
16 MB FLASH MEMORY
24 VDC
400 MH
20 W
(601418)