









Summer Bias Inverter
Input Channels:2 or 3
Input Signal:4-20 mA DC
Input Impedance:250 Ω
Output Signal:4-20 mA DC
Output Load:0–850 Ω
Power Supply:24V DC (±10%)
Power Consumption:< 2.2W
Termination Unit
Wire Size (Field Side):0.5 - 2.5 mm²
Contact Resistance:< 2 mΩ
Dielectric Strength:> 2.5 kV
Insulation Resistance :> 100 MΩ
Current Rating:10-12 A per terminal
Voltage Rating:300-400 V
FIP Interface
Supply Voltage:+5V DC
Power Consumption:500 mA
Isolation:1500 V AC
FIPIO Port:9-pin D-sub
Data Rate:31.25 kbit/s (Fixed)
Bus Topology:Bus with trunk and drops
Analog Output Module
Analog Output
Output Channels:16
Output Signal:4-20 mA
Resolution:16-bit
Accuracy:±0.05% of span
Load Impedance:≤ 850 Ω (at 20 mA)
Max Output Compliance:20 V
MCS Graphic Card Elographics
E27160MKIIA
CONTROL BOARD
Supply Voltage:+5 VDC and +24 VDC
Power Consumption:5 W (typical)
Microprocessor:16-bit or 32-bit
Serial Communication:RS-232
Touchscreen Control Module
TOUCHSCREEN CONTROL MODULE
FOR 90 SYSTEM IOS
Supply Voltage:Typically +24 V DC
Power Consumption:5 - 10 W
Screen Size:5.7 inches
Resolution:320 x 240 pixels
17" Color Monitor V80
E20FFA-BC1
17-inch Industrial Color Monitor
Supply Voltage:24 V DC
Power Consumption:35 W
Input Signals:VGA (D-Sub 15)
Screen Size:17 inches
Aspect Ratio:5:4 or 4:3
16" Industrial Color Monitor
INTECOLOR E01942-20F
COLOR MONITOR
Supply Voltage:24 V DC (±10%)
Power Consumption:30 W
Input Signals:VGA (D-Sub 15-pin)
Screen Size:16 inches (diagonal)
Native Resolution:1280x1024 (SXGA)
Aspect Ratio:5:4
Panel Technology:TFT LCD
16" Industrial Color Monitor
INTECOLOR E01941-20F
COLOR MONITOR
Power Supply:24 V DC (±10%)
Power Consumption:35 W (typical), <1 W (standby)
Input Voltage Range:20-30 V DC
Video Inputs:VGA (D-Sub 15-pin), DVI-D
Communication:USB for touch interface (if equipped)
Inrush Current:<20 A (at 24 V DC)
Digital Slave Input Module
DSI01
Digital Slave Input Module
Input Channels:16 points
Input Voltage:24 V DC (nominal)
Operating Range:19.2-30 V DC
ON Voltage:≥15 V DC
OFF Voltage:≤5 V DC
Input Current:≤3 mA per point (typical)
Input Impedance:7 kΩ

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.