








Analog output module
Manufacturer:GE Fanuc
Series:RX3i PacSystems
Part Number:IC694ALG391
Product Type:Output Module
Module Type:Analog
Number of Outputs:2
Analog input module
Manufacturer:Emerson Automation
Series:PACSystem RX3i
Product Description:Analog input module
Part Number:IC694ALG221
No of Channels:Four (4) input channels
Product Type:Input Module
Nominal Input signal:0-20 mA; 4-20 mA
Module Type:Analog
Channel update rate:2 ms
Number of inputs:4
Digital Resolution:12 bit
Input filter response:325 Hz
Input impedance:250 ohms
Input Filter Response:325 Hz
Common Mode Voltage:200 volts
GAS DETECT IO
IS220YAICS1A
DISCONTINUED BY MANUFACTURER
GAS DETECT IO
SIL IO PACK
ANALOG IO
BPPB BASED
Discrete output module
Series:PACSystem RX3i
Manufacturer:GE Fanuc
Part Number:IC694MDL940
Product Description:Relay output module
Description:Relay Output Module
Response time:15 ms
Product Lifecycle Status:Active
No. of channels:Eight (8)
No. of groups:Four (4)
Switching current:2.0 Amps
No. of channels per group:Four (4)
Output voltage, range:5 - 30 VDC; 5 - 250VAC (50/60 Hz);
Max. Backplane Draw:135 Milliamps
Rated voltage:24 VDC; 120/240 VAC
Inrush Rating:5.0 Amps
Max. Response Time:15 Milliseconds
Minimum load:10 mA
Location:PacSystems PLC I/O Slots
Maximum inrush:5:00 AM
Thermocouple Input Board
Voltage: 24 V DC ±10%
Consumption: ≤15 W (typical)
Channel-to-Channel: ≥250 V AC
Field-to-System: 1500 V AC
Signal Range: -200°C to +1800°C
ETHERNET CONNECTION BOARD
PC BOARD ASSEMBLY
ETHERNET CONNECTION BOARD
CONTROLLER WITH 2 IS BUS CHANNELS
MARK VI
Discrete Input Pack
Channels:16x isolated
Voltage Range:24-125V DC
Current Rating:5mA (min)
Isolation:1500V AC
Power Supply:24V DC (±10%) from backplane
Power Consumption:6W (typical)
Response Time:<1ms (input), <0.5ms (output)
Contact Rating:50,000 operations @ rated load

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.