









Current Transformer
Symmetry resistance
3x 2K7 Ohm 190W 5%
Power:1kV
Primary Current:15 A
Accuracy Class:1 or 3
Voltage:400-440 V
Phase:Three Phase
CONTROL UNIT
CONTROL UNIT
1.5 AMP
24 VDC
4 DIGITAL INPUTS
1 DIGITAL OUTPUT
1 ANALOG INPUT
1 ANALOG OUTPUT
THERMOCLICK INTERFACE USB
SD/MMC INTERFACE
GATE/POWER MODULE BOARD
GATE/POWER MODULE BOARD
SIMOREG DRIVES
POWER-INTERFACE
GATING + SV(POWER-INTERFACE)
(C98043-A1601-L1)
Machinery Control
Series:MM430
Input Voltage:380–480V AC ±10%
Input Frequency:50/60Hz ±5%
Output Power:7.5 kW
C751-009 I/O Module
Digital Inputs (DI) : 8 × 24V DC
Digital Outputs:4 × Relay Outputs
AC capacity:≤250V
Operating Voltage DC:+24 VDC +10%
Power Consumption:≤5W
Storage Temperature:-10˚C- +60˚C
Rectifier interfaces Module
Rectifier interfaces Module
PER2 for infeed/regenerative
feedback Supply units
with Designs H and K 3 AC 500-575V
50/60 Hz and 660-690V 3AC
50/60 Hz
INVERTER CPU BOARD
Processor: Infineon C167xx-series
Flash EPROM: ≥1 MB
SRAM: 128‒512 KB data cache
EEPROM: 8‒16 KB
On-Board Power: +5VDC ±1%
Temperature operating:-15˚C to +70˚C
Replacement IPD card
SINAMICS S120
Replacement IPD card
for air-cooled Basic Line Module
1100kW 500-690V 3AC/1400A
Synchronous servo motor
SIMOTICS S synchronous servo motor
1FK7 Compact 6.0 Nm, 100K, 4500 rpm 1.74 kW
naturally cooled IM B5 (IM V1, IM V3)
power/signal connector plug rotatable by 270°
ABSOLUTE ENCODER 2048 P/REV (ENCODER A-2048)
WITH DRIVE-CLIQ INTERFACE
PERFORMANCE REDUCTION BY 10% DUE TO
ABSOLUTE ENCODER
PLAIN SHAFT, TOLERANCE N
WITH HOLDING BRAKE DEGREE
OF PROTECTION IP64

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.