









Digital Input Module
DIGITAL INPUT MODULE
SYMPHONY PLUS
INFI 90
DI Module. 16 CH
Universal, 32 Jumpers
Universal Signal Converter
Brand:ABB
Input Range:0 → 10 V, 0 → 20mA
Mounting Type:DIN Rail
Operating Temperature Range:-20 → +60°C
Minimum Operating Temperature:-20°C
Maximum Operating Temperature:+60°C
Quad Processor Pack
Two -synchronous- processors
Flash memory for system and applicationprogram
RAM with battery backup (battery located inBKM-0001)
Data comparators for the processors and theirmemory
Minimum and maximum execution timemonitor
Memory error handler
1oo2D functionality
24V and 5V monitoring
Emergency Shut Down Input (24V)
Two outputs (for non-redundant resp.redundant IO)
ACTUATOR
MODUTROL IV MOTOR
NON-SPRING RETURN
FOOT MOUNTED
4-20 MA MODULATING CONTROL SIGNAL
160 DEGREE STROKE
15-30 SECONDS TIMING
8.5 NM / 75 LB-IN TORQUE RATING
15 VA
120 VAC
50/60 HZ
mm Eddy Current Sensor
Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)
Driver board
Input Voltage Range: Typically 24V DC
Output Voltage Range: Dependent on the connected load
Current Rating: Up to 10A
Power Rating: Typically around 240W
Operating Frequency: 1kHz to 20kHz
IGBT MODULE
INVERTER TRIGGER DRIVER BOARD
PROTECTION
Rated Voltage (V_CE):650V
Rated Current (I_C):70A
Peak Current (I_C_peak):Up to 180A
Power Dissipation:150W to 300W
Switching Frequency:Up to 20 kHz
Thermal Resistance (R_thJC):1.5°C/W to 2.5°C/W
Junction Temperature (T_j):-40°C to 150°C
SQ Controller
Local Bus Power +5 VDC at 1.4 A
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz
0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985
AirborneContaminants Class G3

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.