





BUS CONTROLLER
BUS CONTROLLER
SINGLE SLOT
GENIUS
1 CHANNEL
GE RX7I BUS CONTROLLER
1.3 AMP
5 V DC
ANALOG OUTPUT MODULE
Brand:GE Fanuc
Series:Rx7i PACsystem
Part Number:IC670ALG310
Description:Analog output module
Voltage:-10 to 10 Volts
Over/Under Range:50 mV
Resolution:14 bits
Magnitude:14 bits
SPEED CONTROL
Process Input 4–20 mAdc or 1–5 Vdc
Actuator Output 0 to 200 mA, 30 to 45 Ω
Operating Temperature –40 to +85 °C (–40 to +185 °F)
Storage Temperature –55 to +105 °C (–67 to +221 °F)
Speed Trim (optional) 0 to 100 Ω for 0 to –10% speed change
MSLC/DSLC Hand Held Programmer
9907205
DISCONTINUED BY MANUFACTURER
HAND HELD PROGRAMMER
FOR DSLC CONTROL
7-28 VDC
Programmable Coprocessor Module
IC697PCM711
DISCONTINUED BY MANUFACTURER
PROGRAMMABLE COPROCESSOR MODULE
SINGLE SLOT
SERIES 90-70
12 MHZ
80C186 MICROPROCESSOR
SUPPORTS UP TO 512 KBYTES OPTIONAL EXPANSION MEMORY
TWO RS-422/RS-485 OR RS-232 SERIAL PORTS
DS200PCCAG10ACB
DISCONTINUED BY MANUFACTURER
DC POWER CONNECT BOARD
MARK 5
TURBINE CONTROL
MULTI INPUT/ OUTPUT
ON BOARD RAM

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.