








I/O Terminal strip
Brand:GE Fanuc
Series:Versamax
Part Number:IC200TBM002
Type:I/O Terminal strip
Terminals:18
Style:Box-Style
DIN Rail:Compatible
Panel Mounting:Compatible
Protective Door:Yes
Printed Wiring Card:Yes
Power Supply module
Series:PACSystem RX7i
Manufacturer:GE Fanuc
Part Number:IC698PSA350
Nominal Rated Voltage:120/240 VAC, 125 VDC
Part Number:IC698PSA350
Power:100 watts
Input Voltage Range:85 to 264 VAC; 100-150VDC
AC Input Frequency:47-63 Hz
Temperature:0-60 degrees celsius
Ride through time:15 ms
Holdup time:5 ms
Slot Assignment:Slot 0
Product lifecycle:Active
GND Wire:12 AWG
Isolation:1500 Volts DC
Output Voltage:5.1 VDC; +12 VDC; - 12VDC
PROCESSOR BOARD
PROCESSOR BOARD
MARK 5
TURBINE CONTROL
MULTI INPUT/ OUTPUT
ON BOARD RAM
Terminal Board
Series: Mark VIe
Number of channels: 8
Analog output current: 0-20 mA
Customer load resistance: Up to 900 Ω
Size: 15.9 cm high x 10.2 cm wide
Operating temperature: -30 to 65oC
Technology: Surface mount

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.