ALL MANUFACTURERS

Conductivity Transmitter Controller

Power consumption: ≤5VA
TDS: 0.001 ppm to 1000 ppt 
Resistivity: 0.5 Ω·cm to 100 MΩ·cm
Accuracy:±0.5% of reading ±0.001 μS/cm
Power Supply: 100-240V AC ±10%, 50/60Hz
Conductivity: 0.001 μS/cm to 2000 mS/cm (auto-ranging)
1-point offset adjustment
2-point cell constant calibration
Dry calibration (for verification)

177230 Seismic Transmitter

177230 Seismic Transmitter 
01 0 – 25.4 mm/s (0 – 1.0 in/s)
02 3 Hz to 1 kHz (180 to 60 kcps) peak

Analog Output Module

Local Bus Power 12 VDC at 150 mA
Bussed Field Power 24 VDC at 3.2 A/Card 
Field Circuit 24 VDC at 100 mA/Ch
Ambient Temperature -40 °C to +70 °C
Shock 10 g half-sine wave for 11 ms
Vibration 1 mm peak to peak from 2 to 13.2Hz; 
0.7 g from 13.2 to 150 Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3

Digital Input Module

Extensive internal diagnostics for data integrity
NO Open wire detection
Optional redundancy
Internal or external field power selection
Supplies Non-incendive field power
Direct / Reverse Input Indication
Galvanic isolation

CPU 1515-2 PN. 1MB Prog 4.5MB Data

Counter Module

MOUNTING RAIL 530MM (13.8")

MEMORY CARD

MEMORY CARD
SIMATIC S7
FOR S7-1X 00 CPU/SINAMICS
3
3 V FLASH
4 MB

CONNECTION TERMINAL UNIT

Number of Channels: 16 connection points
Isolation: 250V AC
Rated Voltage: 250V AC/DC
Current Rating: 2A per channel 
Contact Resistance: <50mΩ 
Insulation Resistance: >100MΩ @ 500V DC
Dielectric Strength: 2000V AC (50Hz)

Base Unit

RAM Charger Module

Optional C300 Memory Backup 
Series 8 C300 RAM Charger Module
Support up to 4 C300 controllers in one module
Supports redundant power supply inputs through combo cable
Supports Experion soft failure alarm for RAM charger battery status
Typically mounted adjacent to its associated C300 IOTA(s)

3300 NSv Proximity Probes

330901 3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 1.1 in
Minimum case length:  2.5 in
10 1.0 meter (39 in)
01Miniature coaxial ClickLoc connector
with connector protector, standardcable

Governor Detection Board

Frequency range: 1Hz-20kHz
Input sensitivity: 50mV RMS minimum
Isolation: 1500V AC between channels
Analog Inputs:4-20mA position 
Control Outputs: 4-20mA governor control signal
Power Supply:24VDC nominal 
Accuracy: ±0.1% of reading ±1 RPM

TEACH PENDANT MAINBOARD

Operating Voltage: 24V DC
Power Consumption: <15W
Isolation: Opto-isolated I/O for safety signals
CPU: ARM-based microcontroller
Flash Memory: Stores firmware and configuration

35mm-Simatic Stand.Sectional Rail

3300 XL 25 mm Proximity Probe

06 M39x1.5 thread
Minimum Unthreaded Length 0 mm
Minimum Unthreaded Length 0.7 in
10 1.0 metre (3.3 feet)
00 No Armor
05 Multiple Approvals