ALL MANUFACTURERS

S+ Infi-net to Computer Interface Module

Processor: 32-bit RISC processor
Memory:8MB RAM
Power Supply: 24V DC ±10%
Power Consumption: <15W
Operating Voltage Range: 18-30V DC
Screw terminals for power
BNC or ST-type fiber for Infi-net
DB9 or DB25 for serial
RJ45 for Ethernet (if equipped)

Controller Module

CPU: 32-bit RISC processor
Clock Speed: 100-200 MHz 
RAM: 32-64 MB
Flash Memory: 16-32 MB 
Voltage: 24V DC
Power Consumption: 8-15W
Isolation: 1500V AC (input-to-output)

Conductivity Transmitter Controller

Power consumption: ≤5VA
TDS: 0.001 ppm to 1000 ppt 
Resistivity: 0.5 Ω·cm to 100 MΩ·cm
Accuracy:±0.5% of reading ±0.001 μS/cm
Power Supply: 100-240V AC ±10%, 50/60Hz
Conductivity: 0.001 μS/cm to 2000 mS/cm (auto-ranging)
1-point offset adjustment
2-point cell constant calibration
Dry calibration (for verification)

CONNECTION TERMINAL UNIT

Number of Channels: 16 connection points
Isolation: 250V AC
Rated Voltage: 250V AC/DC
Current Rating: 2A per channel 
Contact Resistance: <50mΩ 
Insulation Resistance: >100MΩ @ 500V DC
Dielectric Strength: 2000V AC (50Hz)

RAM Charger Module

Optional C300 Memory Backup 
Series 8 C300 RAM Charger Module
Support up to 4 C300 controllers in one module
Supports redundant power supply inputs through combo cable
Supports Experion soft failure alarm for RAM charger battery status
Typically mounted adjacent to its associated C300 IOTA(s)

Governor Detection Board

Frequency range: 1Hz-20kHz
Input sensitivity: 50mV RMS minimum
Isolation: 1500V AC between channels
Analog Inputs:4-20mA position 
Control Outputs: 4-20mA governor control signal
Power Supply:24VDC nominal 
Accuracy: ±0.1% of reading ±1 RPM

TEACH PENDANT MAINBOARD

Operating Voltage: 24V DC
Power Consumption: <15W
Isolation: Opto-isolated I/O for safety signals
CPU: ARM-based microcontroller
Flash Memory: Stores firmware and configuration

Touchscreen panels

State-of-the-art graphics
Robust and reliable
Truly open platform
Display type:Touch
Display size 15.4"
Brightness:450 cd/m²
Display resolution, ratio:1280 x 800 (16:10)
Processor:ARM9 (1 GHz)
Main memory:1 GB

Power Control drive board

DC Bus Monitoring:0–1000V DC typical
Logic Side: +24V DC (±10%)
Gate Drive Side: +15V/-8V
Current Consumption:<500mA
Gate Drive: Peak 2A
Reinforced Isolation: 2500V AC
Working Voltage: 1000V DC

Control Panel

Intel Core i5/i7 processor (generation varies)
RAM: 8-32GB DDR4
Storage: 256GB-1TB SSD
Power Supply:100-240V AC, 50/60Hz
Role-based access control
Audit trail logging
Cyber security compliant

Enhanced Performance Quad Processor Pack (conformal coated)

24 V supply current: max. 25 mA
5 V supply voltage: 5 Vdc ± 5%
5 V supply current: max 1.2 A
Output supply voltage: 15—31 Vdc
Output resistance: approx. 1.1 kΩ
Short circuit proof: continuous
Voltage (high): 15—32 Vdc
Voltage (low): <4 V (reverse polarity protected)
Input current: approx. 8mA at 24 Vdc
Output current: 750mA per output

CURRENT TRANSDUCER CONTROL BOARD

Input Current Range:±10A (direct input)
Output Signal:4-20mA analog output
Analog Output: 4-20mA (load ≤500Ω)
Accuracy: ±0.5% of full scale
Bandwidth: 10kHz (-3dB point)
Isolation Voltage: 2500V AC

Cartridge U-high HART / Std. FET 300

Input Voltage: 24V DC
Power Consumption: ≤1.5W 
Isolation: 500V AC
Signal Conditioning:16-bit ADC resolution
Analog Input:4-20mA + HART
4-20mA loop drive: ≤500Ω 
Communication Speed: 1200 bps (FSK)
Multidrop Mode: Supports up to 15 devices