Input Voltage: 24V DC (±10%)
Power Consumption: 5W–10W (typical)
Isolation: 500V AC (channel-to-bus)
Processor: DSP or FPGA-based
Flash: 8MB–16MB
Digital I/O: 8–16 channels
DeviceNet or Profibus
RS-232/RS-485
A metal profile
Two plastic cover plates
A ground rail with 16 ground connection screws
Two power rails with M5 holes (+24 V and 0 V)
Eight mounting holes (6.35 mm diameter)
Operating Voltage: 24V DC (±10%)
Power Consumption: 15W typical
Signal Isolation: 2500V AC
Switching Frequency: Up to 20kHz
Gate Drive Outputs:±15V gate drive voltage
Power Requirements: 24 VDC, 9.5W
Voltage Range: 12–29 VDC (Note: No reverse polarity protection)
Fuse Rating: 2 A slow-blow (5 x 20 mm)
Maximum Switched Voltage: 300 VDC / 240 VAC
Maximum Switched Current: 0.5 A
Maximum Switched Power: 10 W
Input Voltage:24V DC (±10%) or 115/230V AC
Output Voltages:+5V, ±15V, +24V DC
Power Capacity:100W (max)
Inrush Current:15A (for 20ms at 230V AC)
Efficiency:>90% (at full load)
Fiber-Optic Signal Isolation :2500V AC
Voltage Rating:1700V
Current Rating:450A (continuous)
Max Junction Temp.:150°C
Switching Frequency:Up to 5kHz
Gate Drive Voltage:+15V/-5V
Isolation Voltage:2500V RMS
Power Consumption:25W (typical)
Protection Response:<2μs (short-circuit)
Input Voltage:3-phase 380-480V AC (±10%)
Output Voltages:+24V DC (control)
Power Capacity:500W (continuous)
Switching Frequency:20kHz (PWM)
Efficiency:>92% (at full load)
