

















Servo board
Product Type: Servo Control Board
Power Consumption: Low to Moderate Power
Operating Temperature : 0°C to +50°C
Automation Frequency Inverter
4 Drive Sizes
Integrated EMC Filter
Brake Chopper
1-Phase or 3-Phase
CPU 414-3 Processor Module
SIMATIC S7-400
CPU 414-3
WORK MEMORY 768 KB
(384 KB CODE / 384 KB DATA)
1ST INTERFACE MPI/DP 12MBIT/S
2ND INTERFACE PROFIBUS DP
3RD INTERFACE FOR IFM ONLY
Digital Output Module - Box of 5
SIMATIC DP, 5 ELECTRON
MODULES FOR ET 200S
4 DOSTANDARD DC 24V/0.5A
15 MM WIDTH 5 PIECES
PERPACKAGING UNIT
memory card
SIMATIC CFast memory card
8 GB,
for IPCs with corresponding slot
scope of supply: 1 CFast 8 GB
RST Extended Analog I/O Board
Series: Mark V
Speedtronic Turbine Control System
Multiple high-resolution input channels
Supports current and voltage signal types
Accurate A/D (Analog-to-Digital)
Operating Temperature: 0°C to +60°C
Storage Temperature: -40°C to +85°C
Humidity: 5% to 95%, non-condensing
ELECTRONIC MODULE
SIMATIC DP
ELECTRONIC MODULE FOR ET 200S
2 AISTANDARD 15 MM WIDE +/-10 V
13 BIT + SIGN +/-5 V; 12 BIT+SIGN
1..5V; 12BIT
CYCLE TIME 65 MS/CHANNEL
WITH LED SF(GROUP FAULT)
PCB CIRCUIT BOARD
Analog Outputs: 4–20 mA
Voltage: 12–24 V DC
Consumption: ≤5 W
Drive Coil Excitation: 10–50 V AC
Standard: -40°C to +70°C (-40°F to +158°F)
Humidity: 0–95% RH (non-condensing)
SWITCH POWER SUPPLY
SWITCH POWER SUPPLY
(80026-096-01)
INPUT: 48VDC 1.5A MAX
OUTPUT: 24VDC/2A
Power Module
SINAMICS G120 Power Module
PM 250 with integrated Class A
filter capable of energy recovery
380-480 V 3 AC +10/-10% 47-63 Hz
Power high overload: 7.5kW at 200% 3s
150% 57s, 100% 240 s
Ambient temperature 0 to +50 °C
Power low overload: 11kW at 150% 3s
110% 57s, 100% 240 s
Ambient temperature 0 to +40 °C
FSC Degree of protection
IP20 without Control Unit and BOP

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.