






Accelerometer
0 2 M8 X 1 integral stud
0 5Multiple approvals (CSA, ATEX, IECEx,)
Sensitivity 10.2 mV/m/s2 (100 mV/g) ±5%.
AmplitudeLinearity±1% to 490 m/ s2 (50 g) peak
FrequencyResponse10 Hz to 15 kHz
TransverseSensitivity Less than 5% of axial.
Amplitude ofResonantPeak20 dB maximum
MountedResonantFrequencyGreater than 30 kHz
8mm Eddy Current Sensor
PR6423/010-040 CON021
Eddy Current Sensor
2 mm (80 mils)
ISO: 8 V/mm (203.2 mV/mil) ± 5%@
temperature range 0 to 45°C(+32 to +113°F)
Proximitor Sensor
1874504
PROXIMITY SWITCH
18745-02
NP0932-1
7200 PROXIMITOR SENSOR
FOR COMBINED PROBE AND EXTENSION CABLE SYSTEM
LENGTH OF 9 METRES (29.6 FEET)
OUTPUT: 7.87 V/MM (200 MV/MIL)
OUT COM: VT(-24 VDC)
1701 FieldMonitor
PROXIMITY SENSOR MODULE / 170133
FIELDMONITOR 1701
3300 SERIES 5 & 8 MM PROBE
SYSTEM LENGTH 9 M
SCALE FACTOR 200 MV/MIL(7.87 MV/UM)
WOBULATOR
TK32E
WOBULATOR
CALIBRATION INSTRUMENT
1AMP
190-250VAC MAX
50/60HZ
90PSI MAX/6.2BAR
STIMULATES SHAFT VIBRATION AND POSITION
FOR CALIBRATING BENTLY NEVADA MONITORS
8mm Eddy Current Sensor
Linear Measurement Range 2 mm (80 mils)
Initial Air Gap 0.5 mm (20 mils)
Incremental Scale Factor (ISF) ISO:
8 V/mm (203.2 mV/mil) ± 5%@
temperature range 0 to 45°C(+32 to +113°F)
Deviation from best fit straight line(DSL)
± 0.025 mm (± 1 mil)@
temperature range 0 to 45°C(+32 to +113°F)
Minimum Shaft Diameter 25 mm (0.79”)
3300 NSv Extension Cable
3300 NSv Extension Cable
065 6.5 meters (21.3 feet)
03 Without stainless steel armor
with connector protector
05 Multiple Approvals

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.