












Analog Input Module
for transmitters in two-wire technique 4...20 mA
voltage inputs 0...1/5/10 V
current inputs 0...20 mA, with safety isolation
resolution 12 bitsrequirement class AK 1 ... 6
F7130A Power Supply Module
F7130A
DISCONTINUED BY MANUFACTURER
POWER SUPPLY BOARD
24VDC
5VDC
H41Q/H51Q
Digital Input Module
1 signal 2.1 ≤ IE ≤ 6.0 mA
0 signal 0.35 ≤ IE ≤ 1.2 mA
wire break ≤ 0.28 mA
short circuit ≥ 6.5 mA
Supply voltage US 8.2 V
Shunt R* 681 Ohm; 1 %; 0.25 W
Space requirement 4 TE
Safety System Central Module
F8650E
DISCONTINUED BY MANUFACTURER
SAFETY SYSTEM MODULE
CPU
25 MHZ
24 VDC
500 MA
2000 MA
SAFETY REMOTE OUTPUT DISCRETE MODULE
SAFETY REMOTE OUTPUT DISCRETE MODULE
XPSMF2
PREVENTA
16 NOT ISOLATED OUTPUTS
24 VDC
REPLACED BY MODICON M580 RANGE
4 Channel Power Distribution Module
F7133
DISCONTINUED BY MANUFACTURER
POWER DISTRIBUTION MODULE
4CHANNEL

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.