Honeywell

SC S300 SAFETY CONTROLLER

Safety Standard Compliance 
IEC 61508 SIL3, ISO 13849-1
Operating Voltage 24 VDC
Power Consumption <15 W
Operating Temperature -10°C to +60°C
Storage Temperature -40°C to +85°C
Mounting Options DIN rail or panel mount

SC S300 SAFETY CONTROLLER

Safety Standard Compliance 
IEC 61508 SIL3, ISO 13849-1
Operating Voltage 24 VDC
Power Consumption <15 W
Operating Temperature -10°C to +60°C
Storage Temperature -40°C to +85°C
Mounting Options DIN rail or panel mount

Red Ethernet Cable

Length 30 feet 
Shielding Shielded Twisted Pair (STP) 
Unshielded Twisted Pair (UTP)
Operating Temperature Range -20°C to +75°C
Storage Temperature Range -40°C to +85°C
Bandwidth Up to 1 Gbps (Cat5e) or 10 Gbps (Cat6)
Impedance 100 Ohms ± 15%
Certifications CE, RoHS, TIA/EIA-568 compliant

FTE BRIDGE MODULE

Communication Protocol Ethernet
with fault-tolerant mechanisms
Redundancy Support
Dual redundant communication paths
Input Voltage 24 VDC or 120/240 VAC
Power Consumption Low power, typically under 10 W
Operating Temperature Range  -20°C to +60°C
Storage Temperature Range -40°C to +85°C
Humidity 5% to 95% non-condensing

Sub-D to Knife terminals FTA

37-pole sub-D male connector 
(CN1) that must be connected 
with (16) RUSIO channelsl 16 sets 
of two knife terminals for the sixteen channels
Each channel has a the following knife 
terminal connections:l A+ terminal that is the (RUSIO) 
signal connection.l A- terminal that is 
the common 0 Volt connection.

Earth Fault Monitor

Temperature -40°C to +75°C
(-40°F to +167°F )
Approvals CE, TUV
DIN EN rails: TS32 / TS35 x 7.5
Input voltage:24 VDC +30/-15% 
Input current:10 mA maximum 25 mA
Voltage typically +4.1 VDC
Resistor (R)approximately 2.8 kOhm

SM RIO 36 inch Carrier

Product Type : SM RIO 36 inch Carrier
Operating temperature : -40 .. +70 degC 
Storage temperature : -40 .. +85 degC
Relative humidity : 10..95% (non condensing)
Pollution : Pollution degree 2 or better
Approvals : CE; UL pending

PWA / I/O LINK MODULE

Module Type I/O Link Module 
Power Supply 24 VDC 
Operating Temperature -20°C to +60°C
Storage Temperature -40°C to +85°C
Humidity 5% to 95% non-condensing

Enraf Vito LT Interface 762

An electronic converter used 
in combination with the VITO probes
HART® communication to tank gauging ATG *2
ATEX KEMA 01ATEX1212
IECEx KEM 05.0014
Kosha certificate; 13-AV4BO-0487
FM I. D. 3015746
CSA certificate 1635480

Interface Board

TDC3000
TDC3000 framework
5 VDC
Approx. 1.5 W
300 mA (nominal)
TDC-specific protocols for 
data transfer and communication

WSI2 Unix coprocessor card

100 MHz
without graphics
used in the UxS and AxM.
with 32, 64, or 128 MB of RAM memory

Tpdgc I/O Circuit Board

TPDG I/O BOARD
INTERFACE FOR PERIPHERALS
6 PERIPHERAL CONNECTIONS  

Turbo Peripheral DG – UxS

Power Requirements 24 VDC
Operating Temperature Range -20°C to 60°C
Humidity Range 5% to 95% 
Mounting Options 
Standard DIN rail or custom rack mounting

Operator Keyboard

Fully programmable customized menus
LCD color touchscreen, and buttons
Softkeys support different colors and text
Touch pad and touch ring
Ergonomic design with padded wrist rest
Variable-speed joystick with integral zoom control
L ocking power connector
Dedicated keys for commonly used functions
Dynamic menu selection
Web interface for configuration and firmware upgrades
Laser cut backlit keys

CIRCUIT BOARD

TDC 3000 systems
Input Voltage: 24 V DC (typical)
Power Consumption: ≤10W
Operating Temperature: -20°C to +70°C
Storage Temperature: -40°C to +85°C

Interface Converter Board

24V DC internal power supply 
within the system
-20 ° C to 70 ° C
5% to 95%, no condensation
Multiple digital/analog input/output interfaces
DIN rail installation or rack mounted installation

HTD Regulator

HTD Regulator
Miscellaneous Modules
Wide Range of Equipment

Control Card

Voltage: 24 VDC (±10%)
Channel-to-Channel: 250 VAC minimum
Channel-to-Bus: 500 VAC reinforced isolation
Channels: 8 or 16
Resolution: 16-bit 
Accuracy: ±0.1% of full scale
Operating Temperature: -40°C to +70°C (-40°F to +158°F)
Humidity: 0–95% RH, non-condensing

RACK 10 SLOT

TKFXX102
RACK 10SLOT COATED
5.1VDC - 15/6AMP
24VDC - 2.8/2.8AMP
3.3VDC - 4/4AMP

MPU TRANSITION MODULE

TMPU1002
DISCONTINUED BY MANUFACTURER
MPU TRANSITION MODULE
COPPER TRANS MOD FOR EXTREME ENG CPU 18-410051-001 DUAL DIODE MODULE
DIN
6A DUAL DIODE MODULE

UCN Series Module

Output Frequency:50 kHz
Processing Capacity:High-speed data processing
Communication Protocol:Supports multiple industry-standard protocols
Operating Temperature:-40°C to +70°C
Memory Size:Extended memory capacity for enhanced system functionality

Power Supply

51198947100
DISCONTINUED BY MANUFACTURER
POWER SUPPLY
115/240 VAC INPUT
50/60 HZ
25 VDC OUTPUT
10 AMP LOAD
550 WATT POWER

Low Level Analog Mux Module

Manufacturer : Honeywell
Product No. : 51309218-125
Product type : Low Level Analog Input Multiplexer RTD FTA
Not CE compliant, not conformally coated
Redundancy not supported
Input channels : 16
Teminals : compression
LLMux RTD FTA with compression terminals
Single IOP interface

Digital Input Power Module

Pulse Input FTA - MC-TPIX52
CE compliant, conformally coated
Use with IOP MU-PPIX02 or MC-PPIX02
Redundancy not supported
Input Points - 8
Terminals - Screw
Size B - 12 inches (307 mm)

Analog Input Module

Low Level Multiplexer Thermocouple FTA - MC-TAMT13
CE compliant, conformally coated
Redundancy not supported
Input channels - 16
Teminals - compression
Size B - 12 inches (307 mm)