









INVERTER MOTHERBOARD
INVERTER MOTHERBOARD
FOR ACS580
3AXD50000716975
Input Voltage Range:380–500V AC (3-phase)
DC Bus Link:Integrated protection
Control Voltage:24V DC
Logic Board Power:Switch-mode PSU
Communication Isolation:1500V AC reinforced
Operating Temp:-15°C to +45°C
Control Module
Analog: 2x 0–10V/4–20mA inputs
Digital: 8x programmable DI
Main circuit up to 690V AC
Functional isolation: ≥2.5kV
Thermal Resilience: ±55°C ambient
CONTROL BOARD
Input Voltage:380–690V AC
Output Power:up to 630 kW
Control Voltage:24V DC (±10%)
Ambient Operation:-15°C to +50°C
Humidity Protection:<95% non-condensing
CE Mark: Low Voltage Directive
Digital I/O: 6 programmable DI
Analog I/O: 2x 0–10V/4–20mA
Panel holder mounting kit
Dynamic Load Rating: ≤5kg
Operating Temperature:-30°C to +60°C
Material Safety:RoHS & REACH compliant
Fire Retardancy:UL94-V2
Spacer Bushings:Nylon PA66
Locking Nuts/Washers:Zinc-Plated
CONTROL UNIT
Input Power (AC):400–690V (±10%) 3-phase
Motor Power Range:250kW–1.5MW
Control Voltage:Single-phase 26V DC to 30V DC (±15%)
Operating Temp:-15°C to +50°C
Harsh Environment:UL 1203
Busbar Terminals:values 8.9Nm ±0.5
AS-Interface Safety ATEX Gateway
CONTROL UNIT
Input Voltage:200–690V AC (-15%/+10%)
Power Range:15–400kW
Control Voltage:Single-phase 24V DC
Relay Outputs:4 × Form-A
AF-650PG: Profibus DP or CANopen
CURRENT MEAS.SCAL
Input Range:0–600A AC/DC
Output Range:±10V DC / 4–20mA
Isolation Voltage:2.5kV RMS
Accuracy:±0.25% FS (25°C)
Bandwidth:DC – 10kHz
Drift:<75ppm/°C
Response Time:<50µs
Hall Effect Sensor: 24V DC
Voltage Meas.Scaling Card
Rated Input Voltage:3300V AC/DC ±10%
Output Signal:±10V DC
Isolation Voltage:8kV RMS
Bandwidth:DC – 5kHz (-3dB)
Linearity Error:≤±0.15% FS
Drift:<50ppm/°C
Output Ripple:<5mV p-p at 50Hz
Response Time:<500µs for step inputs
Input Impedance: 1MΩ nominal
Starter kit
CPU:16-bit Renesas RX630 MCU
Memory:256KB RAM
Communication:2 × Ethernet (10/100BASE-T)
I/O Simulation:Virtual D/I and D/O
Power Supply:24V DC
6 × D/O (Transistor Sink: 0.5A @ 24V DC
Power cables :24V DC
POWER SUPPLY BOARD
AC Input Range: 200–500V AC
Frequency: 50/60Hz nominal
Input Surge Withstand: 4kV
+24VDC Logic Supply: 4A continuous
±15VDC Gate Driver Supply: 0.5A per rail (±2% regulation)
Standby 5VDC: 2A
Total Efficiency (85% load): ≥88%
Operating Temp: -25°C to +70°C

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.