









ANALOG OUTPUT MODULE
ANALOG OUTPUT MODULE
8 CHANNEL
0-20 MA
14 BIT
500/850 OHMS
USE MODULE TERMINATION UNIT
Feedback Module Pulse Encoder
INTERFACE MODULE
FOR PULSE ENCODER
15/24 VDC DIFFERENTIAL
SINGLE ENDED FOR ACS800/DCS800
Analog output module
16 analog outputs, output signal 0/4 ... 20 mA,
channel-by-channel configuration
Load: max. 700 Ohm
Monitoring of loads
Channel-by-channel isolation of outputs
Module is capable of redundant operation
Digital communication with field devices according to
HART protocol (Version 5.0 / 5.1)
Monitoring of modules
Power Supply Unit
3BSE003390R1
DISCONTINUED BY MANUFACTURER
POWER SUPPLY UNIT
115VAC
50/60HZ
24VDC
25AMP
SA167
Tariff Code: 8504409520
Country of Origin: Sweden
Power Supply
51196655100
DISCONTINUED BY MANUFACTURER
POWER SUPPLY MODULE
DUAL NODE
ACX633
120-240 VAC INPUT
50/60 HZ
4 AMP
5/12/27 VDC OUTPUT
20/3/1/0.6 AMP
165 WATT
Stromberg Pulse Amplifier Board
SNAT634PAC
DISCONTINUED BY MANUFACTURER
PULSE AMPLIFIER BOARD
(61049452)

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.