









SERIES SIX GENIUS I/O BUS CONTROLLER
Brand:GE Fanuc
Series:Genius I-O
Part Number:IC660CBB902
Application:Series 6 PLC System
Max I/O Capacity:31 I/O Devices
Configuration:CPU or Handheld Monitor
Phase Type:B
Built-in Diagnostics:Yes
Max Connection Distance:2000 Feet
DS200LPPAG1A
DISCONTINUED BY MANUFACTURER
LINE PROTECTION BOARD
MARK V SERIES
7 JUMPERS
2 TERMINAL BLOCKS
3 TERMINALS PER BLOCK
DS200SSBAG1BAA
DISCONTINUED BY MANUFACTURER
SNUBBER BOARD
MARK 5
TURBINE CONTROL
MULTI INPUT/ OUTPUT
ON BOARD RAM
POWER CONNECT CARD
Input Voltage:+24V DC
Input Range:+18V to +30V DC
Output Voltage:+23.5V to +24.5V DC
Max Current Capacity:40A total
Per-Slot Current:5A max (fused)
Efficiency:>92% (at full load)
Ripple Noise:<100 mV pk-pk
PACSystems RX3i acommunication module
Manufacturer:GE Fanuc
Part Number:IC695PBM300
Product Description:Profibus Master Module
Communication interface:One (1) Profibus Master Port
Product Line:RX3i
Communication protocol:ProfiBus
Catalog:IC695
No. of supported DP slave:125
Product Type:PROFIBUS Master Module
Input data:244 Bytes
Number of Slots:1 (single slot)
Output data:244 Bytes
Enhanced Genius Communications Module
Series:Series 90-30
Manufacturer:GE Fanuc / Emerson Automation
Part Number:IC693CMM302
Product Type:Enhanced Genius Communications Module
Product Description:Genius communication module
Number of Bus Devices Supported:31
Slot width:Single slot
Compatible Host Device:GE Series 90-30 PLC
Slot assignment:Any slot except CPU slot
Mounting location:Series 90-30 baseplate
LEDs:2 (OK LED and COM LED)
Number of supported devices:31
Global Data length (Transmit):128 Bytes
Compatible with GCMs:Not Compatible
Redundancy Memory Xchange module
Series:RX3i PacSystem
Manufacturer:Emerson Automation
Part Number:IC695RMX128
Type:Redundancy memory module
User Memory:128 MB SDRAM
Nodes:Up to 256 per network
Configurable Network:Yes
Network Error Detection:Yes
Hot Insertion and Removal:Yes
TEMPERATURE CONTROL MODULE
Series:Series 90-30
Part Number:IC693TCM302
Output voltage range:18 to 30 Volts DC
Off-state leakage (maximum):0.1 milliAmps
Load current:100 milliAmps
Internal power used:150 milliAmps at 5 Volts DC
Number of channels:8 input / 8 output
Product Lifecycle Status:Discontinued/Obsolete
Thermocouple impedance:30 Ohms (maximum)
I/O MODULE
Brand:GE Fanuc
Series:Genius I-O
Part Number:IC660BRD025
Operating Voltage:5 to 48 Volts DC
Operating Current:0.5 to 1.0 Amp
Max Inrush Current:4.0 Amps
I/O Capacity:32 Points
Location:Genius I/O Bus
Block Type:Current Sinking
POSITIVE LOGIC OUTPUT MODULE
Series:Series 90-30
Manufacturer:GE Fanuc
Part Number:IC693MDL730
Lifecycle status:Active
Power Type:DC
Product Description:Discrete output module
Output power voltage:12 to 24 VDC
No of Channels:Eight (8), single group
Number of Points:8
Load Current per Point:2.0 A
ON Response Time (ms):2 milliseconsds
Nominal output voltage:12 / 24 VDC
OFF Response Time (ms):2 milliseconds
Output type:Transistor
On response time, maximum:2 ms
Off response time, maximum:2 ms

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.