
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Kindly Reminder
Can't Find Your Required Components?
If your specific control system parts are not listed on our website, contact us immediately.
Our procurement specialists will source genuine new components tailored to your technical requirements.
All Amikon-supplied automation parts include:
12 Months Warranty
24h /7 online Service ( info@amikon.cn | +86 18020776786 )
Original new Factory Sealed
Communication Gateway
MLink Hardware Version 2
Internal: Modbus TCP
Fieldbus: Profibus
Modbus RTU/TCP, PROFINET IO
Interfaces Module
Power Supply:24 V DC
Ethernet Port (TCP):- 10/100 Mbps RJ45
Modbus RTU (RS485)
Modbus TCP (TCP/IP) compliance
Isolation:1500 V AC
Operating Temp: -25°C to +70°C
MNS iS Motor Control Center
PROFIBUS DP (-V0) and PROFIBUS DP-V1
MODBUS RTU / TCP
Power Supply 24V DC
Power Consumption Typical 1000mA
MLink Control Unit
Model: M-Link (Motor Link)
Series: ABB MNS iS Intelligent MCC System
Processor:ARM Cortex-A9 @ 800 MHz
Memory:512 MB RAM, 4 GB Flash
MCC Bus Interface:MNS Connect
Operating Voltage: 110-240V AC (50/60 Hz)
Power Consumption:≤ 15 W
MLink Control Unit
Baslc-Modbus TPC+serial/RS 485
Communication Gateway
Product Main Type:MLink
Hardware Version 2
Internal: Modbus TCP
Fieldbus: Profibus, Modbus RTU/TCP, PROFINET IO
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.