
HVD BOARD
Voltage Rating: 3.3 kV, 6.6 kV
Control Voltage: 24 VDC
Power Consumption: <20 W
Operating Temperature: 0°C to +55°C
Humidity: Up to 95% RH (non-condensing)
Current Monitor Board
Power Supply: 24V DC
Type: Current Monitor Board
Operating Temperature: Ranges from 0°C to 60°C
Communication Interface: RS-232, RS-485, or similar
Control Card
Catalog Description:
V PP C905 AE101; CCB-2 COMPLETE
Long Description:
V PP C905 AE101
Rigi Crowbar Drive PCB
Power Supply:24V
Operating Temperature Range
Typically -20°C to +60°C
Storage Temperature Range
-40°C to +85°C
CVMI Board
Voltage Input Range:24 VDC or 110/220 VAC
Current Input: 1-10 A
Power Supply: 24 VDC or 48 VDC
Operating Temperature Range: -20°C to +60°C
Storage Temperature Range: -40°C to +85°C
HVD Board
Power Supply: 24 V DC
Communication Protocol:
Ethernet, Modbus TCP/IP
Operating Temperature Range:
-20°C to +60°C
Control module
Power Supply: Typically 24 V DC (±20%)
Power Consumption: Around 10 W
Operating Temperature Range: -20°C to +60°C
Storage Temperature Range: -40°C to +85°C
Humidity: 5% to 95% (non-condensing)
Protocols Supported: CAN, Modbus
PP D113 B01-25-111000: AC 800PEC
Long Description:Containing:
Slot ANYIO-1 (U4) CEX2-Bus RS422
Slot ANYIO-2 (U5) Anybus/Modbus TCP
Slot Opt. Mod.1 (U7) UF D128
Slot Opt. Mod.2 (U8) UF D128
Slot Opt. Mod.3 (U9) UF D128
Slot Opt. Mod.4 (U10) empty
Slot Opt. Mod.5 (U11) empty
CONTROL BOARD
4 channels (0-20mA, 4-20mA)
8 channels
RS-485, Ethernet, Modbus
24V DC
-20°C to +60°C
Control Module
Part Number: UNS0118A-Z
Type: Control Module
Voltage: 24V DC
Operating Temperature: Typically -20°C to +60°C
Storage Temperature: -40°C to +85°C
IGCT Module
Blocking Voltage 4500 V DC
Reverse Voltage:30 V
Max RMS Current:4000 A
Peak Surge Current :32 kA
Turn-On Time: ≤ 3 µs
Turn-Off Time: ≤ 5 µs
Switching Loss: ≤ 15 kJ/s at 500 Hz
Communication Module
Order Code:3BHE019958R0101
Functional Designation:UA D206 A
Power Supply:5 V DC
Consumption: 500 mA (max)
Data Rate:300 bps – 115.2 kbps (per port)
Isolation:500 V AC
Interface Module
Signal Channels:16 single-ended analog inputs
Voltage: ±10V, ±5V, ±1V, 0–10V
Current: 4–20mA, 0–20mA
Resolution:16-bit (including sign bit)
Accuracy:±0.05% of full scale (25°C)
Sampling Rate:10 ms/channel
Input Impedance:>1 MΩ
Overvoltage Protection:±30V continuous
Common-Mode Rejection:>120 dB at 50/60 Hz
INTERFACE BOARD
Data Rates:9.6 kbps – 12 Mbps
Power Supply:24 V DC
Power Consumption:≤ 2.5 W
Isolation:500 V AC
Function:PROFIBUS DP-V1 Slave Interface
Controller Module
CPU: 32-bit RISC processor
Clock Speed: 100-200 MHz
RAM: 32-64 MB
Flash Memory: 16-32 MB
Voltage: 24V DC
Power Consumption: 8-15W
Isolation: 1500V AC (input-to-output)
PEC80 Converter Signal Int
Input Voltage Range: 24V DC
Operating Voltage: 15–30V DC
Current Consumption: 50–200 mA
Isolation Voltage: ≥500V
Analog inputs: ±10V, 4–20mA
Digital inputs :TTL/relay contact
Control Module
Operating Voltage: 24V DC (±10%)
Power Consumption: 5–10W
Isolation: 1500V AC
CPU: 32-bit RISC-based processor
Clock Speed: 100–200 MHz
Memory Flash:16–32 MB
Digital I/O: 24V DC
Circuit Board
Supply Voltage: 24V DC (±10%)
Power Consumption: 15W (typical)
Operating Current: 0.5-1A
Isolation Voltage: 2000V AC
Main Processor: 32-bit DSP or microcontroller
Clock Speed: 100-200MHz
Communications I/O Module
Supply Voltage: 24V DC (±10%)
Power Consumption: 3.5W (typical)
Primary Protocol: Profibus DP
Data Rate: 9.6kbps to 12Mbps
Connector Type: 9-pin D-sub
Isolation: 1500V AC
Digital Inputs: 8 channels
Communications I/O module
Supply Voltage:24V DC (±10%)
Power Consumption:4W (typical)
Inrush Current:<15A (20ms)
Backplane Current:500mA max
Output Isolation:3000V AC
Data Rates:9.6 kbps – 12 Mbps
Connector:9-pin D-sub (RS-485)
Address Range:0–126
Isolation:1500V AC
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.