ALL MANUFACTURERS

Analog In/Output Module

8 analog inputs
8 analog outputs
Connection possibility single-ended or differential
Power supply for up to 4 potentiometers
Temperature inputs for up to 4 Pt100/Pt1000 sensors
2-wire or 4-wire inputs for Pt100/Pt1000 sensors
Wire break detection for the inputs (for voltage and temperature)
Short circuit proof outputs

I/O MODULE

CONTROLLER M1 PLC 
64MB DRAM
400MHZ
FACTORY 

Digital I/O module

compact CAN slave module
16/32 channels can be freely configured as input or output
Digital outputs each with 1 A continuous current
Two internally connected CAN interfaces for loop-through of the cable
Galvanic isolation between CAN interfaces and control electronics
Baud rate and node ID can be set via rotary switch
Supply voltage 18 to 34 VDC
Operating range 0 to +60°C without additional cooling
Full wiring without additional backplanes

PCB Card

PCB Card
24 VDC
-20°C to 60°C 
Modbus TCP/IP

HTD Regulator

HTD Regulator
Miscellaneous Modules
Wide Range of Equipment

ROTARY ENCODER

ROTARY ENCODER
10-30 VDC
HTL
M8 THREADED SHAFT
12-PIN M16 CONNECTOR
1024 PPR
IP64

CURRENT TRANSDUCER MODULE

CURRENT TRANSDUCER MODULE
+/-24V
25 OHMS
RATIO: 1:4000

Displacement sensor

Up to 5000 mm (typically)
High, typically <1 μm
±0.05% FS (Full Scale)
Analog (0-10V, 4-20mA)
Digital (SSI, CANopen, Profibus, EtherCAT)
-40°C to +85°C

Multipair Cable

Wire Gauge 22AWG
Reel Length (Imperial) 1000f
Voltage Rating 300V
Reel Length (Metric) 304.8m

Current Input Module

Number of input channels 16 channels, 
module isolation (*5)
Rated input range 4 to 20 mA
Permissible input range 0 to 25 mA
Input impedance during Power-OFF 500 kΩ minimum
Data update frequency 40 ms
Temperature drift ±16 µA/10 °C
Withstand voltage 1.5 kV AC between input signal and system for 1 minute