









SC S300 SAFETY CONTROLLER
Safety Standard Compliance
IEC 61508 SIL3, ISO 13849-1
Operating Voltage 24 VDC
Power Consumption <15 W
Operating Temperature -10°C to +60°C
Storage Temperature -40°C to +85°C
Mounting Options DIN rail or panel mount
Red Ethernet Cable
Length 30 feet
Shielding Shielded Twisted Pair (STP)
Unshielded Twisted Pair (UTP)
Operating Temperature Range -20°C to +75°C
Storage Temperature Range -40°C to +85°C
Bandwidth Up to 1 Gbps (Cat5e) or 10 Gbps (Cat6)
Impedance 100 Ohms ± 15%
Certifications CE, RoHS, TIA/EIA-568 compliant
FTE BRIDGE MODULE
Communication Protocol Ethernet
with fault-tolerant mechanisms
Redundancy Support
Dual redundant communication paths
Input Voltage 24 VDC or 120/240 VAC
Power Consumption Low power, typically under 10 W
Operating Temperature Range -20°C to +60°C
Storage Temperature Range -40°C to +85°C
Humidity 5% to 95% non-condensing
Sub-D to Knife terminals FTA
37-pole sub-D male connector
(CN1) that must be connected
with (16) RUSIO channelsl 16 sets
of two knife terminals for the sixteen channels
Each channel has a the following knife
terminal connections:l A+ terminal that is the (RUSIO)
signal connection.l A- terminal that is
the common 0 Volt connection.
Earth Fault Monitor
Temperature -40°C to +75°C
(-40°F to +167°F )
Approvals CE, TUV
DIN EN rails: TS32 / TS35 x 7.5
Input voltage:24 VDC +30/-15%
Input current:10 mA maximum 25 mA
Voltage typically +4.1 VDC
Resistor (R)approximately 2.8 kOhm
PWA / I/O LINK MODULE
Module Type I/O Link Module
Power Supply 24 VDC
Operating Temperature -20°C to +60°C
Storage Temperature -40°C to +85°C
Humidity 5% to 95% non-condensing
POWER SUPPLY
Input Voltage Range
85-264 VAC / 90-350 VDC
Frequency Range 47-63 Hz
Output Voltage 24 VDC (nominal)
Output Current Up to 10 A
Power Output Capacity 240 W
Efficiency ≥ 90%
Ripple and Noise ≤ 50 mV
DC power supply
PAC8000 I/O
Power Module-Field Input24VDC In
5A@12VDC Out;
Power for 2/1 (IS) modules
Use2/1 (IS) modules power
with support for load sharing redundancy
PAC8000 Intrinsically Safe module
DC power supply (8 modules)
Analog Input Module
Ovation Distributed Control System
8 to 16 analog input channels
Analog signals
4-20 mA, 0-10 V
16-bit resolution for high precision
0°C to 60°C
Base Connection Unit
Input Voltage 24 VDC
Mounting Type Rack-mounted or integrated
within the robot controller system
Connection Types Multi-port connectivity
for cables and communication modules
Operating Temperature-10°C to 55°C
Storage Temperature -25°C to 70°C
Humidity 5% to 95% non-condensing

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.