
DC551-CS31 Digital I/O Bus Module
1SAP220500R3001
DISCONTINUED BY MANUFACTURER
DC532 DIG IN/OUT MODULE
PanelView Plus 6 700 Terminal Touch Screen
Operator Input:Touch
Display Type:Color active-matrix TFT
Lifecycle status:End of life
Resolution:640 x 480, 18-bit color graphics
Touch:Analog Resistive
Display Color:Color
Input Type:Touchscreen
Communication:Ethernet and RS-232
Input Power:18 to 32 Volts DC
Memory:512 MB RAM
PanelView Plus Communication Module
2711PRN6
COMMUNICATION MODULE
PANELVIEW PLUS
DH/RIO/DH-485
PV PLUS 700 TO 1500 DH PLUS MODULE
FOR PANELVIEW PLUS 700-1500 AND PANELVIEW PLUS CE
WITH (1) 9-PIN D-PLUG CONNECTOR FOR RS232 AND (1) 6-PIN PHOENIX CONNECTOR FOR DH485
Country of Origin: United States
17910B32
DISCONTINUED BY MANUFACTURER 06/30/2015
PLC BLOCK I/O
30 VDC
32 POINT MODULE (32 OUTPUT) PLC BLOCK I/O
Block I/O Module
179124B8
DISCONTINUED BY MANUFACTURER 2015-06-29
MODULE BLOCK I/O 24V DC 32 POINT MODULE
24B8 BLOCK I/O MODULE
24V DC
32 POINTS: 24 INPUTS (3 GROUPS OF 8)
8 OUTPUTS (1 GROUP OF 8); OUTPUT VOLTAGE RANGE: 10-30V DC
Tariff Code: 8538903000
Country of Origin: United States
Module Power Panel
NMPP02
DISCONTINUED BY MANUFACTURER
MODULE POWER PANEL
W/AUCTIONEERING
NET 90
Four Channel Control Card Catalytic Input
Power Consumption: 12.8W 8.5W
Drive: Constant Current.
Initial Accuracy: ±1%.
Electronic in 1mA stepsfrom 90 to 315mA.
Maximum Drive Voltage: 10V
Protected against short circuit and open circuit.
40 ohms (including sensor) at 200mA.
Full Scale Signal Range: 15mV to 300mV
±100mV from centre at 2V bridge voltage.
Adjustment: Electronic adjustment
of bridge balance and signal gain.
Open circuit. Short circuit single bead failure.
ENGINEERING CONTROL CARD
05701A0361
ENGINEERING CONTROL CARD
18-32 VDC
1.5W
13.2CM. X 2.5CM X 17CM
UNS 0863 A-P_ Digital I/O card
HIEE305082R0001
DISCONTINUED BY MANUFACTURER
DIGITAL I/O CARD / PC BOARD
UNS 0863A-P
6181P17TPXPH
DISCONTINUED BY MANUFACTURER 01/30/2009
VERSAVIEW 1700P INTEGRATED DISPLAY COMPUTER W ROTATING MEDIA
17-INCH TFT DISPLAY
TOUCH SCREEN
PERF FEATURES PENTIUM 4 2.0 GHZ
1024 MB RAM
40 GB ROTATING MEDIA HARD DRIVE
1 HALF-LENG PCI SLOT
4 SER PORTS
Tariff Code: 8537109170
Country of Origin: Taiwan
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.