
Flex Controlnet Adapter
FLEX CONTROLNET ADAPTER
REDUNDANT MEDIA
FOR CONTROLNET 24VDC
COMM AND STATUS LED'S
Right End Cap
Series CompactLogix
Part Number/Catalog No. 1769-ECR
Module Type Right End Cap
Product Line CompactLogix
Current draw at 5.1V DC 5 mA
Module Type Right End Cap Module
Current draw at 24V DC 0 mA
Operating altitude 2000 m (6562 ft)
Shipping Weight 2 lbs.
North American temp code T3C
Shipping Dimensions 8X8X5 in.
IEC temp code T4
Series A and B
Proximity System Test Kit
1773130201
PROXIMITY SYSTEM TEST KIT
TK-3E
1 AMP
95-250 VAC
50/60 HZ
90 PSI (6.2 BAR)
EOI
Power Supply:24V DC (±20%)
Power Consumption:5W (max)
Output Channels:8 (configurable)
Isolation Voltage:1500V AC
Load Capacity:2A per channel
Flex 32 Point Digital Output Module
I/O MODULE
FLEX I/O
32 POINT DIGITAL
CURRENT SOURCING
PROTECTED OUTPUT
14 AMP
24 VOLT DC
ANALOG OUTPUT MODULE
ANALOG OUTPUT MODULE
8 CHANNEL
0-20 MA
14 BIT
500/850 OHMS
USE MODULE TERMINATION UNIT
1771 16 Point Digital Output Module
1771OBD
OUTPUT MODULE
DIGITAL
16 POINT
2 AMP
10-60 VDC
1771 6 Point Input Module
1771IR
DISCONTINUED BY MANUFACTURER
INPUT MODULE
6 POINT ANALOG
RTD 3W PLC-5
0.950 AMP
5 VDC
Proximity Sensor
7471206050300
SEISMOPROBE VELOCITY TRANSDUCER
HIGH TEMPERATURE
TERMINAL BLACK TOP MOUNT
Power Supply
3BSE002098R1
POWER SUPPLY SB512 110-230VAC/DC OUT 1AMP 10-24VDC
Tariff Code: 8504409520
Country of Origin: Sweden
Feedback Module Pulse Encoder
INTERFACE MODULE
FOR PULSE ENCODER
15/24 VDC DIFFERENTIAL
SINGLE ENDED FOR ACS800/DCS800
Analog output module
16 analog outputs, output signal 0/4 ... 20 mA,
channel-by-channel configuration
Load: max. 700 Ohm
Monitoring of loads
Channel-by-channel isolation of outputs
Module is capable of redundant operation
Digital communication with field devices according to
HART protocol (Version 5.0 / 5.1)
Monitoring of modules
Remote I/O to EIP Drives
Product Type:Communication module
Description:Network Connector
Part Number:AN-X2-AB-DHRIO
Baud Rate:57.6 to 230.4 kbaud
Power supply:24 VDC
Voltage:12 Volts DC
Supported Ethernet devices:ControlLogix; CompactLogix
Current:100 milliamps
Stepping Motor Drive Control Module
6410007NNN
DISCONTINUED BY MANUFACTURER
STEPPER MOTOR DRIVER
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.