
Aluminum Electrolytic Capacitors
1500 µF 350 V
Aluminum Electrolytic Capacitors Radial,
Can - Screw Terminals 47mOhm @ 100Hz
12000 Hrs @ 85°C
LAN Communications Card
TURBINE CONTROL SYSTEM
MARK V
SPEEDTRONICS
W/FIRMWARE
16 DIGIT DISPLAY
Discrete Output Pack
Input Voltage:24V DC (±10%)
Power Consumption:5W (max)
Output Channels:16 channels (sourcing)
Output Type:Solid-state (MOSFET)
Load Voltage:12-48V DC
Current per Channel:0.5A continuous (2A peak)
Isolation:1500V AC
OEI-BOARD
Power Supply:24V DC (-15%/+20%)
Power Consumption:6W typical
Optical Interfaces:2× 100BASE-FX (1300nm)
Electrical Interface:1× 10/100BASE-TX
Isolation:1500V AC
Data Rate:100Mbps full-duplex
Thyristor Modules
POWER BLOCK MODULE
1400V 410A DUAL
641-TT210N14KOF
Infineon Technologies
Gate Trigger Current - Igt:200 mA
Holding Current Ih Max:300 mA
Output Current:410 A
AC DRIVE ADJUSTABLE FREQUENCY
AC DRIVE
ADJUSTABLE FREQUENCY
POWERFLEX 70
480 VAC
3 PHASE
1.1 AMP
0.37 KW
0.5 HP
PANEL MOUNT
INTERFACE MODULE - FULL NUMERIC LCD
MANUAL
WITH BRAKE
Torque-RPM Adapter
Model Number:1-G070A-2
Type:Torque-RPM Signal Conditioner
Application:Motor Drive Systems
Compatibility:Reliance Electric DCS/DC Drives
Power Requirement:120V AC ±10%, 50/60Hz
Power Consumption:15VA max
Isolation:1500V AC (input-to-output)
Control board
Processor:32-bit DSP
Memory:2MB Flash, 512KB SRAM
Control Algorithms:PID with adaptive tuning
Sampling Rate:10kHz
Analog Inputs:8 channels
Digital I/O:24 channels
Encoder Interface:Differential RS-422
Communication Gateway
MLink Hardware Version 2
Internal: Modbus TCP
Fieldbus: Profibus
Modbus RTU/TCP, PROFINET IO
REMOTE I/O NODE CONTROLLER
Network Protocol:Ovation High-Speed Bus (HSB)
Data Rate:100 Mbps (Full Duplex)
Node Capacity:Up to 64 I/O modules
Maximum Distance:2 km
Processor:32-bit RISC @ 400MHz
Memory:128MB SDRAM, 64MB Flash
Scan Time:10ms (typical for 64 modules)
I/O Capacity:2048 points (mixed I/O)
Analog Input Module
SPARE PART
INPUT MODULE
PMOD ASSEMBLY
ANALOG INPUT
8 CHANNEL
VOLTGAGE W/ TEMPERATURE SENSOR
PROXPAC XL Proximity Transducer
2 8 3300 XL 8 mm probe with MultipleApprovals
1 5 1.5 in (38 mm)
0 3 5 3.5 in (96 mm)
0 0No fittings; two plugs and twowashers
0 2 3/4-14 NPT
(Required if orderingStandoff Adapter Option.)
3300 NSv Proximity Probes
330901 3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 0.0 in
Minimum case length: 1.9 in
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cabe
00 Not required
3300 XL 8 mm Proximity Probes
330103 3300 XL 8 mm Probe
M10 x 1 thread,without armor
Minimum unthreaded length: 0 mm
Minimum case length: 160 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
3300 XL 11 mm Proximity Probes
330703 3300 XL 11 mm Probe
M14 x 1.5 thread,without armor
Minimum unthreaded length:0 mm
Minimum length:100 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 Multiple Approvals
3300 XL 11 mm Proximity Probes
330703 3300 XL 11 mm Probe
M14 x 1.5 thread,without armor
Minimum unthreaded length:0 mm
Minimum length:100 mm
10 1.0 meter (3.3 feet)
11Miniature coaxial ClickLocconnector
with connector
00 Not required
Circuit Board Card
Input Voltage:24V DC (typical)
Power Consumption:15W max
Isolation:1500V AC (channel-to-channel)
Signal Range:4-20mA, 0-10V, ±10V
Input Channels:16+ analog/digital
Output Channels:8+ analog/digita
Processing Speed:100MIPS (typical)
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.