















PM1507 Power Supply
SIMATIC PM 1507 24 V/3 A
Stabilized power supply for
SIMATIC S7-1500
input:120/230 V AC
output: 24 V DC/3 A
PROFINET IO Device Interface Module
SIMATIC ET 200MP
PROFINET IO device Interface module
IM 155-5 PN HF, forET 200MP electronic modules
Up to 12 IO modules without PS
Up to 30 IOmodules with additional PS
Integrated 2-port switch; RJ45 shared device MRP
IRT >=0.25 ms; Isochronous mode FW update
I&M0...3; Prioritized startup, S2redundancy
Flex XT 8 Point Analog Input Module
1794IE8XT
ANALOG INPUT MODULE
FLEX I/O
CURRENT OR VOLTAGE
8 CHANNELS SINGLE ENDED INPUT
EXTENDED TEMPERATURE -20 TO +70 DEG
OPEN STYLE
DIN RAIL MOUNT
IP20
CONFORMAL COATED
Relay Output Module
Communication Protocol:Modbus TCP/IP, DeviceNet
Data Rate:Up to 1 Mbps
Power Consumption:L ess than 4W
Operating Temperature:-40C to +70°C
Mounting Type:Panel Mount
Analog Output Module
Points:4, commoned-return, DC-coupled
Output current range:
4–20 mA output, controlled
0–22 mA over-range
0 mA output capability (step function <2 mA)
Type:TMR
Resolution:12 bits
Diagnostic:Forced-switch diagnostic (FSD)
Over-range protection:36 V DC, continuous
Main Processor (UMP) Module
Power consumption: Typically 15-30W
Operates on 24V DC
Operating Temperature: 0°C to +60°C
Storage Temperature: -40°C to +85°C
Humidity: 5% to 95% non-condensing
S7-1500 Front Connector
SIMATIC S7-1500
Front connector in push-in design
40-pole, for 35 mm widemodules incl
4 potential bridges and cable ties
INVERTER TRIGGERING MODULE
SIMOVERT MASTERDRIVES
INVERTER TRIGGERING MODULE
IGD5 FOR UNITS 3-PH
660-690V AC
50/60 HZ AND 890-930 V DC
171 A

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.