
CABLE EXTENSION MODEL 3300 XL 8MM
085 8.5 meters (27.9 feet)
00 Standard cable
05 CSA, ATEX, IECEx Approvals
3300 XL 8 mm Proximity Probes
330103 3300 XL 8 mm Probe
M10 x 1 thread,without armor
Minimum case length: 50 mm
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
05 CSA, ATEX, IECEx Approvals
Communication Gateway module
Modicon Modbus protocol
Modbus/TCP protocol
Proprietary Bently Nevada protocol
Data Throughput: Up to 10,000 tags/sec
Latency: <5ms (EtherNet/IP)
Max Concurrent Clients: 32
Recip Rod Position Monitor
Signal Accepts from
1 to 4 proximityprobe signals
InputImpedance 10 kΩ
OutputImpedance 510 Ω
TransducerPower Supply -24 Vdc
16-channel Temperature Monitor
Power Consumption 3 watts nominal
Input ImpedanceGreater than 1 MΩ for eachlead input.
Signal Accepts from 1 to 16 RTD
or isolated tip TC transducersignals.
Resolution 1°C or 1 °F.
Temperature Monitor
350061
TEMPERATURE MONITOR
AVAILABLE
REBUILD SURPLUS
NEW
NEVER USED
REPAIR YOURS
24 HOUR RUSH REPAIR
5-10 DAY REPAIR
2 YEAR RADWELL WARRANTY
Temperature Monitor
350060
MODULE
TEMPERATURE MONITOR
6 CHANNEL
ACCEPTS FROM 1 TO 6 RTD OR TC TRANSDUCER SIGNALS
NOMINAL POWER CONSUMPTION OF 7 WATTS
(133819-01)
Hydro Monitor
Channels: 6 or 8 channels
Velocity Seismometers:4–20 mA
Measurement Range: 0–5000 psi
Sampling Rate: Up to 10 kHz
Power Supply: 24 VDC (±10%)
Aeroderivitive GT Vibration Monitor
OutputImpedance 550 Ω
Direct signal 4 Hz to 30 kHz, -3 dB
Low-passcorner200 Hz (-3 dB)
High-passcorner25, 75 or 100 Hz (-3 dB)
TransducerPower Supply 23 Vdc nominal at 43 mA max
Proximity/Seismic Monitor Module
350042M
DISCONTINUED BY MANUFACTURER
PROXIMITOR / SEISMIC MONITOR MODULE
4 CHANNEL
Country of Origin: United Kingdom
Proximitor Seismic Monitor
Model Number: 3500/42M
Part Number: 140734-02
Velocity sensors :4–20 mA or mV/mm/s
-24V DC power supply
Vibration:0–20 mm/s (RMS)
Range: Typically 0–10 g (RMS)
Accuracy: ±1% of full scale
4-Channel Relay Module
PowerConsumption:5.8 Watts typical
Type :Single-pole, double-throw(SPDT) relays
EnvironmentalSealing :Epoxy-sealed
Arc Suppressor:250 Vrms, installed asstandard
Contact Life:100,000 cycles @ 5 A, 24 Vdcor 240 Vac
Rack Interface Module
350020
RACK INTERFACE MODULE
3500 SERIES
LED INDICATORS
5 AMP
24 VDC
120 VAC
4.75 W
RS232 SERIAL COMMUNICATIONS
3500 SYSTEM CHASSIS RACK
3500050101000000
DISCONTINUED BY MANUFACTURER
RACK MODULE
16 SLOT
TACHOMETER I/O MODULE
Input signal range: +10.0 V to -24.0 V
OperatingTemperature: -30 ºC to +65 ºC
RPM/Min Accuracy: ± 20 rpm/min
Number of channels: 12
Output Impedance: 550 Ohm
Frequency: 50 or 60 Hz
Process Variable Monitor
+/-10 Vdc I/O:-10 Vdc to +10 Vdc
4-20 mA:Barrier I/O 4-20 mA DC
Isolation:500 Volts
Voltage Compliance:13.66 V
Power Consumption:7.0 Watts, typical
Tachometer Module
350050
DISCONTINUED BY MANUFACTURER
TACHOMETER MONITOR MODULE
4 CHANNEL
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.