ALL MANUFACTURERS

DRIVER CARD

DRIVER CARD
EC01 2/SOL
24 VDC

Video Graphics Card

Card type PCIe x16
Graphics memory :128 MB DDR2
Form factor (card/bracket) :ATX/ATX
Carddimensions1:6.6” x 4.38” / 16.76 x 11.13 cm
Connectors :DVI-I x 2
Connector adapters :2 DVI-I to HD15
Max displays per card :2

Wire/cable/dataCable

PVC or similar durable, 
flexible material
Voltage Rating:  300V to 600V
Cable Length: 10 meters
Temperature Rating: -20°C to +90°C

Card

Type: Printed Circuit Board
Power Supply:24V DC
Operating Temperature Range:
0°C to 60°C

Inverter Drive

Power Rating: 11 kW
Current Rating: 27 A
Input Voltage: 380–480 V AC, 3-phase
Output Frequency: 0-550 Hz
Overload Capacity: 150% for 1 minute
Enclosure Rating: IP20 / UL open class (NEMA 1)

GAS DETETCTOR

Detection Range: 
Typically 0 to 100%
Output Signal: 
4-20 mA with HART
Communication Protocols: 
Supports MODBUS and ASCII

HVD Board

Power Supply: 24 V DC
Communication Protocol: 
Ethernet, Modbus TCP/IP
Operating Temperature Range: 
-20°C to +60°C

DU/DT Filter

Input Voltage: 380–690 V AC, 3-phase
Rated Current: 65 A
Protection Rating: IP22

Level and Pressure Measuring

Process Temperature Range:
 -40°C to +150°C (-40°F to +302°F)
Process Pressure Range: 
-1 to +40 bar (-100 to +4000 kPa)
Output Signal: 4…20 mA/HART
Power Supply: 14…36 V DC
Protection Rating: IP66/IP68 (0.2 bar)
Wetted Materials: Stainless Steel (1.4435)
Probe Length: Up to 9,000 mm

Power Supply Module

Product Type: Power Supply Module
Nominal Rated Voltage: 24 volts DC
Input Voltage Range: 18 to 32 VDC
Input Power: 160 watts at full load
Output power: 90 watts
Location on Baseplates: Leftmost slot
DC Output: +5VDC, +12 VDC, -12 VDC

ADVANCED MICROCONTROLLER

ADVANCED MICROCONTROLLER
18-36 VDC
ETHERNET CONNECTION
VGA CONNECTION

INSULATION MONITORING DEVICE

Rated insulation voltage AC 800 V
Rated impulse voltage/pollution degree 8 kV/3
Nominal system voltage Un AC, 3/(N)AC 0…793 V
Supply voltage USAC 88…264 V
Frequency range US 42…460 Hz
Supply voltage US DC 77…286 V
Frequency range US 42…460 Hz

PCB CARD

Operating Voltage: 5Vto 24V DC
Environmental Resistance: 0°C to 60°C

Transformers

SEPARATION TRANSFORMER 
55V TO 24V/24V (200W) 
FOR SINAMICS GM150(IGBT)

Control Board

Operating Voltage: 24V DC
Temperature Range: -20°C to +60°C
Humidity Range: 5% to 95%, non-condensing.

Dmv Camera

Sensor: CMOS 
Resolution: 26 Megapixels 
Pixel Size: Typically 3.45 µm
Operating Temperature: -10°C to +50°C 
Storage Temperature: -20°C to +60°C
Power Supply: 12V DC

POWER SUPPLY

PHASES:3; PN(KW):0,648
UPRI(V):575(600)-500-460(480)- 400(415)-230(240)-200
USEC(V DC):24
ISEC(A DC):27/32,5 (60/40 CEL)
F(HZ):50...60
VECTOR GR./SHIELD WNG.:II0 /0
PROTECTION CL.:I; TA/ISOKL:60 /B
W(%):4,2; IP00
 TYPE OF TERMINALS:SCREW CONNECTION
INSTALLATION:SCREW; 
EN 61558-2-6, EN61131-2 >UL
CSA-RECOGNIZED
SAFETY ISOLATING TRANSFORMER

Drive Controller

DC Bus Nominal Voltage:DC 300V
Nature of Firmware:Standard
Rated Current:12A
Multi interface, general purpose

PROFINET fieldbus module

Product or component type:Communication module
Product compatibility:Lexium 32M
Accessory / separate part destination:Servo drive
Number of addresses:256
Electrical connection:2 connectors RJ45
4 LEDs (green/red) for communication status

Servo motor

Range compatibility:PacDrive 3
Device short name:SH3.....P
Product or component type:Servo motor
Maximum mechanical speed:8000 rpm
rated supply voltage:115...480 V
Network number of phases:Three phase
Continuous stall torque:1.25 N.m at 115...480 V three phase
Continuous power:690 W
Maximum current Irms:5.7 A

Servo motor

Maximum mechanical speed 8000 rpm
 rated supply voltage 115...480 V
Continuous stall current 2.9 A
Continuous power 1130 W
Speed feedback resolution 128 periods
Torque constant 0.7 N.m/A at 120 °C
Back emf constant 48 V/krpm at 20 °C
Maximum axial force Fa 80 N

ACCELEROMETER

Acceleration Range: ±2g, ±5g, ±10g, or ±50g
Voltage output, typically 0-5V or 0-10V
Supply Voltage:  5V DC or 12V DC
Operating Temperature: -40°C to +85°C

Analog Input Module

Universal Input Output IOTA
Input Channels 1 16 Channels 
Common Mode Voltage, dc to 60 Hz -6 to +5 V peak
A/D Converter Resolution 16 bits 
Normal Mode Rejection Ratio, at 60 Hz 19 dB
Normal Mode Filter Response Single-pole RC, -3 dB @ 6.5 Hz
Input Impedance (voltage inputs) > 10 M Ω powered
Input Scan Rate 50 ms 

High-Speed Network Communication Modules

Supports fiber-optic medium
NFPA Class B or Class A operation
Data is immune to all environmental noise
Optical isolation prevents ground loops
High-Speed NFN fiber-optic medium
Fiber type: 62.5/125 micrometers (multi-mode); 
50/125 micrometers (multimode), 
or 9/125 micrometers (single mode)
Maximum attenuation: 10 dB with 62.5/125 μm cable, 6

CONTROL OPERATING UNIT

SIMOVERT 
MASTERDRIVESVECTOR CONTROL
MOTION CONTROLOPERATING UNIT 
W. INTEGRATED MEMORY OP 1S