
























AC frequency converter
PowerFlex 753 AC Drive
with Embedded I/O
Standard Protection
Forced Air, AC Input with DC Terminals
Flange Type, 104 Amps, 55kW ND
45kW HD, 400 VAC, 3 PH, Frame 5
Filtered, CM jumper installed (preferred)
DB Transistor, Blank (No HIM)
AC frequency converter
PowerFlex 753 AC Drive
with Embedded I/O
Standard Protection
Forced Air
AC Input with DC Terminals
Flange Type
37 Amps
18.5kW ND
15kW HD
400 VAC
3 PH, Frame 3
Filtered, CM jumper installed (preferred)
DB Transistor, Blank (No HIM)
AC frequency converter
PowerFlex 753 AC Drive
with Embedded I/O
Standard Protection
Forced Air, AC Input with DC Terminals
Flange Type, 22 Amps, 11kW ND
7.5kW HD, 400 VAC, 3 PH, Frame 2
Filtered, CM jumper installed (preferred)
DB Transistor, Blank (No HIM)
ControlLogix Digital AC Input Module
Part Number/Catalog No:1756-IN16
Series:ControlLogix
Module Type:Digital AC Input Module
Inputs:16
Input Voltage:24 Volts Ac
Operating Voltage Range:10-30 Volts AC
Input Delay Time:Programmable 9 or 18 milliseconds
Minimum Operating Current:5 milliamperes at 10 Volts AC, 60 Hertz
Maximum Operating Current:1.2 milliamperes at 30 Volts AC, 60 Hertz
Maximum Input Current, Off-State:2.75 milliamperes
ControlLogix Fast Digital Module
Series:ControlLogix
Module Type:Fast Digital DC Isolated Input
Inputs:16 Individually Isolated
Input Voltage:12-24 Volts DC
Operating Voltage Range:10-30 Voltage DC
Input Delay Time:14 microseconds plus selected filter time
Current Draw (5.1 Volts):275 milliamps
Current Draw (24 Volts):3 milliamps
Power Dissipation:3.8 Watts
POINT I/O Analog Output Module
Series:POINT I/O
Module Type:Analog Output Module
Outputs:4 Single Ended
Data Format:Signed Integer
External DC Supply Current:220 mA
Output Signal Range:4 to 20 mA, 0 to 20 mA
Output Resolution:16 bits across 0 to 21 mA
Conversion Type:Digital-Analog
Conversion Rate:20 microseconds
Resolution:14 bits
VDC Logic I/O Module
I/O Type: 32-channel
Nominal: 24 VDC
Operating Range: 19.2–30 VDC
Field-to-Logic Isolation: 1500 VAC
Backplane Power: 120 mA @ 5 VDC (typical).
Field Power: 32 x 7 mA = ~224 mA @ 24 VDC (max).
Counter module
Counter modules
Modicon Premium
2 channels modularity
thermal tripping protection
4.5 to 6W, 40kHz
SLC 500 DeviceNet Scanner Module
Module Width:Single Slot
Compatible controllers:SLC 5/02 or later
Pass through: Supported
Communication Port:One (1) DeviceNet
Data Transfer speed:125Kbps
Linear Plug:1787-PLUG10R
Indicators:Mod/Net Status - red/grn; I/O Status - red/grn
Mounting:DIN Rail; Panel Mounting
Storage Temperature:-40 to 85 C (-40 to 185 F)
Stratix Managed Switches
Series:Stratix Managed Switches
Part Number:1783-MX08T
Relative humidity:5% to 95%
Connector Type:10/100 Base-T Copper Ethernet Port
Enclosure:Open type
Number of Ethernet Copper ports:8
Operating Temperature:-40 to 60 degrees Celsius
Network Type:Ethernet
PROCESSOR MODULE
Double format PL7 processor,
Modicon Premium,
Internal RAM
48Kwords program & data
PL7 Junior/Pro
Discrete Input module
Module Type:Digital AC/DC Input Module
Number of Inputs:8 Inputs
Voltage Category:120 Volts AC/DC
Compatible Chassis:1771-AB thru 1771-A4B
AC Operating Voltage:87-138 Volts
DC Operating Voltage:97-138 Volts
Backplane Current:75 Miliamperes
Power Supply Board
Model: SDCS-POW-H01
Part Number: 3ADT318700R1501
Application: Dedicated power supply unit
Input Voltage Nominal: 24 V DC
Range: 20–30 V DC
AC Input Option: support 100–240 V AC (50/60 Hz)
Primary Output: 24 V DC
Continuous: 5–10 A
Peak Current: Up to 15 A
Excitation plate
Model: SDCS-FEX-4a
Part Number: 3ADT314500R1501
Input Voltage Nominal: 24 V DC
Range: 20–30 V DC
Voltage Range: 0–250 V DC
Current Capacity: Up to 20–50 A
Continuous Output Power: ~5–10 kW
Reference Input: 0–10 V DC or 4–20 mA
DCSLink communication options board
Supply Voltage Nominal: 24 V DC
Supply Voltage Range: 20–30 V DC
Power Consumption:Typically <5 W
Operating Temperature: -25°C to +70°C (-13°F to +158°F).
Storage Temperature: -40°C to +85°C (-40°F to +185°F).
Humidity: 5–95% RH (non-condensing).
FIRING PULSE TRANSFORMER BOARD
Model: SDCS-PIN-H41
Part Number: 3ADT320600R1501
Pulse Voltage: 5–24 V DC
Isolated Pulse Voltage: Typically 10–30 V
Output Current: 1–2 A
Primary-to-Secondary Isolation: ≥2500 V AC
Insulation Resistance: >100 MΩ
Power supply board
Model: SDCS-PIN-H51
Order Code/Part Number: 3ADT320700R1501
Nominal Input Voltage: 24 V DC
Input Voltage Range: 20–30 V DC
Primary Output: 24 V DC
Output Current: Typically 2–5 A
Continuous Power: ~60–120 W
Typically ≥85%
Remote Access Dial-In Data/Fax Modem
REMOTE ACCESS DIAL-IN DATA/FAX MODEM
V.90 COMPATIBLE
EXTERNAL
WITH 1 X RS-232 INTERFACE
24 VDC POWER
CompactLogix 5370 L1 controller
Ethernet nodes:8 Nodes
No. of Task:32 Task
No. of Program per Task:100
No. of Embedded Inputs:(16) 24 VDC
Module Type:Processor Module
Communication:Ethernet
Input Power:24 Volts DC
Memory:512KB
Communication Cable:6 Point
Shipping Weight:3 pounds
Counter module
Counter modules
Modicon Premium
4 channels modularity
current limiter protection
8 to 11.5W
40kHz
Analog output module
Analog input module
Modicon Premium
4 high level fast inputs
16 bits conversion
500mA at 5VDC
Analog output module
Analog output module
Modicon Premium
4 outputs
12 bits coversion
900mA at 5VDC
Maximum load inductance:300 µH
Maximum load capacitance:0.1 µF
Communication module
Range of product:Altivar
Product or component type:Communication module
Communication port protocol:Profibus DP V1
Electrical connection:1 female connector SUB-D 9
Transmission rate:9.6 kbps...12 Mbps
Redundant Net Interface Module
REDUNDANT NET INTERFACE MODULE
CAGE CARD
24 VDC
(PN-14251 / 14251)

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.