ALL MANUFACTURERS

Redundant H1 Terminal Block

I/O Count 20 points
Input Type:120V ac
Analog Circuits:4 Inputs, 1 Output
Protocol:DF1
Safety Feature:Master Control Relay
Digital Outputs:8 Contact Outputs
No. of Discrete Inputs:Twelve (12)
Input Voltage Type:120 Volts AC
Voltage Range:79-132 Volts AC
Output Type:Eight (8) Relay

Redundant H1 Terminal Block

Input Power Rating 35 VDC @ 500m A
AmbientTemperature-40 °C to +70 °C
Shock 10 g half-sine wave for 11 ms
Vibration 1 mm peak to peak from 2 to 13.2 Hz
0.7 g from 13.2 to 150 Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3
Relative Humidity 5 to 95% non-condensing 

Fieldbus H1 Card

Local Bus Power 12 VDC at 300 mA
Fieldbus Power 9 to 32 VDC at 12 mA/Port 
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec 
Vibration 1mm Peak to Peak from 2 to 13.2Hz;0.7g from 13.2 to 150Hz 
AirborneContaminantsISA-S71.04 –1985 AirborneContaminants Class G3
Relative Humidity 5 to 95% Non-Condensing IP 20 Rating 
Terminal Block keyPosition D6  

Interface Terminal Block

Field Power 35 VDC at 1 A 
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz;0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 AirborneContaminants Class G3
Relative Humidity 5 to 95% Non-Condensing 
Terminal Block Key Position Set according to I/O card installed 

Serial Interface Module

SERIAL INTERFACE CARD
12 VDC
300 MA
2 PORT
D4 TERMINAL BLOCK KEY POSITION
Simplex SIC (Serial Interface Card), 
LocalBus Power Rating 12 VDC 300mA
Ambient Temperature -40 to 70 degrees C

ADAPT Aeroderivative Monitor

Displacement: 0–500 µm peak-to-peak
Velocity: 0–20 mm/s RMS
Acceleration: 0–50 g peak
Frequency Response: 0.5 Hz to 30 kHz
Sampling Rate: Up to 100 kHz 
Operating Temperature: -40°C to +85°C 

Wind Turbine Monitor

Vibration Velocity: Typical range 0–20 mm/s RMS 
Vibration Acceleration: 0–50 g peak
Frequency Range: 0.5 Hz to 10 kHz
Speed Range: 0–3,000 RPM 
Analog Outputs: 4–20 mA 
Operating Temperature: -40°C to +85°C 
Voltage: 18–30 VDC
Power Consumption: <5 W

Wind Turbine Monitor

Vibration Velocity: Typical range 0–20 mm/s RMS 
Vibration Acceleration: 0–50 g peak
Frequency Range: 0.5 Hz to 10 kHz
Speed Range: 0–3,000 RPM 
Analog Outputs: 4–20 mA 
Operating Temperature: -40°C to +85°C 
Voltage: 18–30 VDC
Power Consumption: <5 W

PowerFlex 753 AC drive

Series:PowerFlex 753
Frames:1..5, 8...10
Enclosure Type:AC and DC Input with Precharge
Frames:2 2...7
Enclosure Type 2:IP20/IP00, NEMA/UL Type Open
Voltage:400 Volts AC/540 Volts DC
Horsepower:300
Filtering:Yes
Default CM Cap Connection:Jumper Installed

Frequency drive

PowerFlex 753 AC Drive
with Embedded I/O, Standard Protection
Forced Air, AC Input with DC Terminals
Open Type, 37 Amps, 18.5kW ND
15kW HD, 400 VAC, 3 PH, Frame 3
Filtered, CM jumper installed (preferred)
DB Transistor, Blank (No HIM)

Frequency drive

PowerFlex 753 AC Drive
with Embedded I/O, Standard Protection
Forced Air, AC Input with DC Terminals
Open Type, 30 Amps, 15kW ND, 11kW HD
400 VAC, 3 PH, Frame 3, Filtered
CM jumper installed (preferred)
DB Transistor, Blank (No HIM)

Frequency drive

Part Number/Catalog No.:20F11NC015JA0NNNNN
Series:PowerFlex 753
Frames:1..5,8...10
Enclosure Type:AC & DC Input w/Precharge
Frames:2 2...7
Enclosure Type 2:IP20/IP00, NEMA/UL Type Open
Voltage:400V AC/540V DC
Filtering:Yes
Default CM Cap Connection:Jumper Installed

Vibration Transmitter

05 0-5 mils pp (0-125 μm pp)
50 5.0 meters (16.4 feet)
01 35 mm DIN rail clips
01 CSA Division 2

Thrust Transmitter

25 25-0-25 mils
50 5.0 meters (16.4 feet)
01 35 mm DIN-rail clips
01 CSA Division 2

Proximitor Probe Extension Cable

Voltage Rating: Rated for ≤ 250V AC/DC
Impedance:50–100 Ω
Temperature Range: -40°C to +120°C 
7.5-meter (24.6 ft) cable length

3300 NSv Proximity Probes

330901 3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 0.0 in
Minimum case length:  4.0 in
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals

3300 XL 8 mm Proximity Probes

330102 3300 XL 8 mm Probe
3/8-24 UNFthread, with armor
Minimum unthreaded length: 0.4 in
Minimum case length: 5.6 in
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required

Digital Input Module

Input Channels:32
Galvanic Isolation: 1500 VAC RMS or ±1500 VDC
Isolation Technique:Optical (in IOM)
DI Power Voltage Range:18 to 30 VDC
ON Sense Voltage/Current:13 VDC (min) or 3 mA (min)
OFF Sense Voltage/Current:5 VDC (max) or 1.2 mA (max)
nput Impedance:4.2 K
Absolute Delay Across Input Filter and Isolation:5 ms ± 20%

3300 XL 8 mm Proximity Probes

330104  3300 XL 8 mm Probe
M10 x 1 thread,with armor
Minimum unthreaded length: 0 mm
Minimum case length: 50 mm
05 0.5 meter (1.6 feet)
01Miniature coaxial ClickLocconnector 
with connectorprotector, standard cable
00 Not required

3300 NSv Proximity Probes

330901 3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 0.0 in
Minimum case length: 1.0 in
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cable
00 Not required

3300 XL 8 mm Proximity Probes

330101 3300 XL 8 mm Probe
3/8-24 UNFthread, without armor
Minimum unthreaded length: 0.0 in
Minimum case length: 8.5 in
05 0.5 meter (1.6 feet)
01Miniature coaxial ClickLocconnector 
with connectorprotector, standard cable
05 CSA, ATEX, IECEx  Approvals

Frequency AC drive

Series:PowerFlex 753
Frames:1..5, 8...10
Enclosure Type:AC & DC Input w/Precharge
Frames:2 2...5
Enclosure Type 2:Flange (NEMA/UL Type 4X/12 back)
Voltage:400V AC/540V DC
Filtering:Yes

Frequency AC drive

PowerFlex 753 AC Drive
with Embedded I/O
Standard Protection
Forced Air, AC Input with DC Terminals
Type 12 / IP54, 43 Amps, 22kW ND
18.5kW HD, 400 VAC, 3 PH, Frame 3, Filtered
CM jumper installed (preferred)
DB Transistor, Blank (No HIM)

Frequency AC drive

Series:PowerFlex 753
Frames:1..5,8...10
Enclosure Type:AC & DC Input w/Precharge
Frames:2 2...7
Enclosure Type 2:IP54, NEMA/UL Type 12
Voltage:400V AC/540V DC
Filtering:Yes
Default CM Cap Connection:Jumper Installed

AC frequency converter

PowerFlex 753 AC Drive
with Embedded I/O
Standard Protection
Forced Air, AC Input with DC Terminals
Type 12 / IP54, 11.5 Amps
(Fr1 5.5kW ND, 4kW HD/Fr2 5.5kW ND, 5.5kW HD)
400 VAC, 3 PH, Frame 2, Filtered
CM jumper installed (preferred)
DB Transistor, Blank (No HIM)