ALL MANUFACTURERS

POWER MODULE

POWER MODULE
690VAC
1150DC
3KHZ
750A
60HZ (76517S0R13)

Digital I/O Module

16 / 32 digital channels
16 channels can be configured as input or output
Configurable interrupt inputs
Status display for each channel via LED
Supply voltage 18 to 34 VDC
Supply voltage protected against reverse polarity
Cost effective and space saving

RELAY CONTROL

RELAY CONTROL
DC 220V
9 make and 5 break contacts
8 CONTACTS 120 VAC

BISTABLE RELAY

BISTABLE RELAY
DC 220V
9 make and 5 break contacts
8 CONTACTS 120 VAC

I/O module

Head module for CANopen slave stations
Up to 30 I/O modules per slave station
Optional integrated power supply
Transfer rate 10 Kbaud to 1 Mbaud
Bus length to 5000 m (signal repeater required)
Two internally connected CAN interfaces for loop-through of the cable
Galvanic isolation between CAN interfaces and control electronics
Node address can be set via rotary switch

Analog In/Output Module

8 analog inputs
8 analog outputs
Connection possibility single-ended or differential
Power supply for up to 4 potentiometers
Temperature inputs for up to 4 Pt100/Pt1000 sensors
2-wire or 4-wire inputs for Pt100/Pt1000 sensors
Wire break detection for the inputs (for voltage and temperature)
Short circuit proof outputs

I/O MODULE

CONTROLLER M1 PLC 
64MB DRAM
400MHZ
FACTORY 

Digital I/O module

compact CAN slave module
16/32 channels can be freely configured as input or output
Digital outputs each with 1 A continuous current
Two internally connected CAN interfaces for loop-through of the cable
Galvanic isolation between CAN interfaces and control electronics
Baud rate and node ID can be set via rotary switch
Supply voltage 18 to 34 VDC
Operating range 0 to +60°C without additional cooling
Full wiring without additional backplanes

PP D113 B01-25-111000: AC 800PEC
Long Description:Containing:
Slot ANYIO-1 (U4) CEX2-Bus RS422
Slot ANYIO-2 (U5) Anybus/Modbus TCP
Slot Opt. Mod.1 (U7) UF D128
Slot Opt. Mod.2 (U8) UF D128
Slot Opt. Mod.3 (U9) UF D128
Slot Opt. Mod.4 (U10) empty
Slot Opt. Mod.5 (U11) empty

FEEDER PROTECTION AND CONTROL RELAY

Ref615
Ref615E_D
Hbfcacabnca1Bnn1Xd
Uaux= 48-250 Vdc/100-240 Vac
In= 1/5A (I)
In= 1/5A (Io)
Pq Less Than 10W
Fn= 50/60 Hz
111921
Com0034
2Rca023019A0004C
Ust-2A
Mv-sqr

COMMUNICATION UNIT

COMMUNICATION UNIT
FOR USE WITH RTU560 SERIES RACK
3 SERIAL PORTS
1 ETHERNET PORT
32 BIT CPU (INTEL 586TM)
COMPACT FLASH CARD SLOT
(560CMU02 R0001)

PCB Card

PCB Card
24 VDC
-20°C to 60°C 
Modbus TCP/IP

Flush Mounted

DTU
Flush Mounted
24 V
GVSB293923V0002
DTU Pushbutton for TSZ, Flush Mounted

Feeder terminal

1A or 5A 
100V (also suitable for 110V)
50 Hz / 60 Hz 
250 In (peak value) dynamic,100 In for 1s, 
2 Un /√3 continuous.
≤ 0.1 VA with In

OVERLOAD PROTECTOR

NSD570 (1KHW001179R2011)
400V AC
0.1A to 570A

HTD Regulator

HTD Regulator
Miscellaneous Modules
Wide Range of Equipment

ROTARY ENCODER

ROTARY ENCODER
10-30 VDC
HTL
M8 THREADED SHAFT
12-PIN M16 CONNECTOR
1024 PPR
IP64

CURRENT TRANSDUCER MODULE

CURRENT TRANSDUCER MODULE
+/-24V
25 OHMS
RATIO: 1:4000

Circuit Board

Voltage: 24V DC
Current: Varies based on the specific application
Number of Inputs: 16
Number of Outputs: 16
Input Voltage: 24 VDC
Output Voltage: 24 VDC
Operating Temperature: -20°C to 60°C (-4°F to 140°F)

Displacement sensor

Up to 5000 mm (typically)
High, typically <1 μm
±0.05% FS (Full Scale)
Analog (0-10V, 4-20mA)
Digital (SSI, CANopen, Profibus, EtherCAT)
-40°C to +85°C

GATE DRIVER BOARD

Gate Driver Board
Control board
ACS880-04, ACS580-04
ACS880-104-R8i FOR R8i , 
ACS580-04 FOR R10 AND R11

CONTROL CARD

Main control board 
16 Ch. 218/48
I/O Module
24-250 VAC/DC relays

Connection Unit Module

Connection Unit 
32 Ch. 24/48
I/O Module
24-250 VAC/DC relays

Multipair Cable

Wire Gauge 22AWG
Reel Length (Imperial) 1000f
Voltage Rating 300V
Reel Length (Metric) 304.8m

Drive Control Unit

DRIVE CONTROL UNIT
COATED
BLANK
24 VDC
(64607901)