ALL MANUFACTURERS

CONTROL MODULE

CONTROL MODULE
E300 OVERLOAD RELAYS
193 IEC RELAY
I/O ONLY
6 INPUTS / 3 RELAY OUTPUTS
24 V DC CONTROL VOLTAGE

Overload Relay

COMMUNICATION MODULE
E300 OVERLOAD RELAYS
IEC
DEVICENET
193/592 IEC/NEMA

Analog Input Module

Channels: 15
Signal Types:
standard current input:4-20 mA 
voltage inputs0-5 VDC
Input Range:  0-10 VDC, ±10 VDC, 
Signal Conversion: 16-bit 
Input Impedance: High input impedance f
or accurate measurements without significant loading.
Input Accuracy: Typically ±0.1% 
Operating Temperature:  -20°C to +60°C

Analog output module

Channels: 16 or 32 
current output:4-20 mA 
voltage output:0-10 VDC or ±10 VDC 
Output Range:0-10 V, ±10 V, 4-20 mA
Resolution: 16-bit 
Accuracy:
±0.1% of full scale for voltage outputs
±0.1% of full scale for current outputs

NSv Proximitor Sensor

3300 NSv Probe
3/8-24 UNF thread
withoutarmor
5.0 metre (16.4 feet) systemlength
panel mount 
0 0 Not required

NSv Proximity Sensor

7.0 5.9 ± 0.9
Extension cabledc resistance
Center conductor: 0.220Ω/m (0.067 Ω/ft)
RecommendedGap Setting 1.0 mm (40 mils)
IncrementalScale Factor 7.87 V/mm (200 mV/mil)
OperatingTemperature-52°C to +177°C
StorageTemperature-52°C to +177°C (-62°F to+351°F)

6ES7405-0DA01-0AA0

SIMATIC S7-400
power supply PS 405
4 A, 24/48/60 V DC
5 V DC/4 A

Analog output Module

SIMATIC S7-300
Analog output SM 332
isolated, 2 AO, U/I
resolution 11/12 bits
20-pole
Removing/inserting 
with active backplane bus possible

ANALOG INPUT MODULE

SIPLUS S7-300 
SM 331-20-pole -25...+70°C 
with conformal coatingbased on 
Analog input isolated 2 AI
Resolution 9/12/14 bits
U/I/thermocouple/resistor
alarm diagnostics
1x 20-pole
Removing/inserting with active backplanebus

Servo Control

Design Euro card
Functionality Valve specific
valve parametersfixed
User software Application parameters from 
PC viauser software ProVRD
Operating system MS-DOS
Supply voltage 18...30VDC 
Solenoid current ranges 0,8 / 2,7 / 3,5A
Current consumption max. 2,0A
Pre-fuse 1,6 / 3,15A fast 
Ambient temperature 0...+50°C
Connection DIN 41612F, 48-pole
Command signal inputs 0...+/- 10V

Axis Controller Card

Axis Control Card 
UIMC-III-1
for Universal GSM Machine
Radisys Part Number UIMC III-I

VME Interface Control Card

Work With MV Series Controllers
6U Single-Slot VME Modules
running at 40 MHz
can be configured with 2, 4, or 8 MB

Circuit Board

Analog Inputs:4-20 mA, 0-10 VDC
Digital Inputs/Outputs: TTL, 24 VDC
Power Supply Input: 24 VDC or 48 VDC
Logic Supply: 5 VDC or 3.3 VDC
Operating Temperature: -20°C to +70°C
Storage Temperature: -40°C to +85°C

Circuit Board

Analog Inputs 4-20 mA, 0-10 VDC
Digital Inputs/Outputs TTL or 24 VDC
Power Supply Input: 24 VDC or 48 VDC
Operational voltage for logic and I/O circuitry: 5 VDC or 3.3 VDC
Operating Temperature: -20°C to +70°C
Storage Temperature: -40°C to +85°C

AC servo drive

SERVO DRIVE
S700 SERIES
3 PHASE
6 AMP
120-480 VAC
50/60 HZ
4.5 KVA
IP20

Gateways

PROFIBUS DP-V0 Master 
to Modbus RTU Slave
Product Category: Gateways
Product: X-Gateways
Data Rate: 12 Mb/s
Interface Type: Ethernet, USB
IP Rating: IP20
Operating Supply Current: 200 mA
Product Type: Gateways
Series: Anybus X-Gateway
Subcategory: Ethernet & Communication Modules

Communication Module

Tricon
TCM SERIES
2 X NET LINK PORTS
4 X 9 PIN SERIAL PORTS
1 X 9 PIN DEBUG PORT

Current/Ground Fault Sensing Module

Current/Ground Fault Sensing Module 
for E300 Overload Relays, 
0.5-30A
DIN Rail / Panel Mount, 
with Line- and Load-Side Power Conductor Terminals, 
Directly Replaces 193-ECPM2 
Series A

Operator Panel

Operating Temperature 0° to 50° C
Storage Temperature -20° to 80° C
Operating Humidity 5 to 95% (non-condensing)
Air Composition No corrosive gases permitted
Power Budget Requirements 5 VA @ 8--30 VDC

Safety-Related Controller

Number of outputs 8 
Output voltage L+ minus 2 V
Minimum load 2 mA for each channel 
Internal voltage drop max. 2 W at 2 A 
Leakage current (with lowlevel)max. 1 mA at 2 V 
Number of counters 2
Inputs 3 on each (A, B, Z) 

CPU module

Processor Atom E3815 1.46 GHz
Main 256 MB with ECC
Static RAM 2 MB with ECC
backed up by battery
1 GB on-boad flash memory
SDHC (4 to 32 GB) Class 10
D-sub 9 pins, male (*2)
Full/Half duplex (software settings)
Synchronisation Asynchronous

CPU module

SH-4A (SH7730) 256 MHz
128 MB with ECC
1 MB with ECC, backed up by battery 
128 MB on-board flash memory
RS-422/RS-485: 
120 Ω built-in, 
ON/OFF (DIP switch settings)
SB bus (single)

CPU module

Operation 0° to 55°C 
Transportation/storage  40° to 85°C (*1)
Dust 0.3 mg/m3 or less
Resistance to corrosive gases 
ANSI/ISA S71.04 Class G2 (Standard) 
(ANSI/ISA S71.04 Class G3, option)
Resistance to vibration 
0.15 mm P-P (5 to 58 Hz), 1 G (58 to 150 Hz)
Resistance to shock 
15 G, 11 ms 
(during power-off, for sine half-waves in XYZ-directions)
Altitude 2000 m or less

CPU module

High-performance
high-elibility modular controller
Memory with ECC
Low heat dissipation eliminates the need for a fan
Awealth of RAS features -CPU self-diagnostics
temperature monitoring. 1/0 diagnostics, and more
power supply module, local bus (SB bus)
and control network can all be duplexed
and all modules are hot-swappable
Can function as link active schedulers 
(L ASs) for low-speed voltage mode (H1) 
FOUNDATION Fieldbus segments
and link up FOUNDATION Fieldbus-enabled feld devices

CPU module

Processor Atom E3815 1.46 GHz
Main 256 MB with ECC
Static RAM 2 MB with ECC
backed up by battery
1 GB on-boad flash memory
SDHC (4 to 32 GB) Class 10
D-sub 9 pins, male (*2)
Full/Half duplex (software settings)
Synchronisation Asynchronous
4 Ethernet ports : RJ45 modular jacks