
PLC MODULE
High-speed processor
real-time data processing and control
Typically supports 16/32 digital inputs
Supports 4-20 mA or 0-10 V
-10°C to +55°C (14°F to 131°F)
20°C to +70°C (-4°F to 158°F)
10% to 90% non-condensing
PLC MODULE
High-speed processor
real-time data processing and control
Typically supports 16/32 digital inputs
Supports 4-20 mA or 0-10 V
Interface Board
Low power design
typically <10 W
Multiple I/O ports for
interfacing with sensors
actuators, and controllers
Optimized for high-speed
Interface Board
24 VDC
Low power design
typically <10 W
Multiple I/O ports for
interfacing with sensors
actuators, and controllers.
Optimized for high-speed
communication to minimize latency
Interface Board
TDC3000
TDC3000 framework
5 VDC
Approx. 1.5 W
300 mA (nominal)
TDC-specific protocols for
data transfer and communication
WSI2 Unix coprocessor card
100 MHz
without graphics
used in the UxS and AxM.
with 32, 64, or 128 MB of RAM memory
ETL600 equipment
Conversion of the signals from LF
(L ow Frequency) to RF (RadioFrequency)
DPLC modem MOD600
Up to four AF modems NSK600
Data-multiplexer MUX600
Safety Controller Board
UCSB CONTROLLER MODULE
256 MB DDR2 SDRAM
600 MHZ INTEL EP8059
28 VDC
Proximitor Probe
Unthreaded Length Option : 00 = 00mm
Overall Case Length Option : 03 = 30mm
Total Length Option : 05 = 0.5 metre (1.6 feet)
Connector and Cable-Type Option : 02 = Miniature coaxial ClickLocTM connector, standard cable
3300XL 8 mm Proximity Probe
5mm and 8mm Standard Mount Probe
nthreaded Length Option : 00 = 0.0 inches
Overall case length option : 08 = 0.8 inches
Total length option :10 = 1 metre.
Connector option : 02 = With miniature male coaxial connector.
Diameter : 8mm
Configurations type and thread : Standard, 3/8-24
Lead Armor : No
Input power : -17.5 Vdc to -26 Vdc
at 12 mA Max consumption.
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.