
Power Supply Module
24 VDC, 20 A output
Input voltage range: 100-240 VAC (47-63 Hz)
Operating temperature range: -40 to +70 degrees Celsius
Short circuit protection
Overload protection
EMI/RFI filtering
UL/CSA certified
Power Supply module
Series:PACSystem RX7i
Manufacturer:GE Fanuc
Part Number:IC698PSA350
Nominal Rated Voltage:120/240 VAC, 125 VDC
Part Number:IC698PSA350
Power:100 watts
Input Voltage Range:85 to 264 VAC; 100-150VDC
AC Input Frequency:47-63 Hz
Temperature:0-60 degrees celsius
Ride through time:15 ms
Holdup time:5 ms
Slot Assignment:Slot 0
Product lifecycle:Active
GND Wire:12 AWG
Isolation:1500 Volts DC
Output Voltage:5.1 VDC; +12 VDC; - 12VDC
IGCT Board
Turn-On Pulse: +20V ±5%, 500A peak
Turn-Off Pulse (Overdrive): -20V plateau followed
Stored charge extraction: ≥100µC
di/dt tolerance: >2kA/µs during turn-off
Energy per Switching: <3mJ/cycle
+24V DC Input (Logic): 200mA
Jitter tolerance: ±30ns
Operational ambient: -40°C to +85°C
Weigh Scale Module
1771WS
DISCONTINUED BY MANUFACTURER
WEIGH SCALE MODULE
SINGLE VESSEL
PLC5
1 CHANNEL
1.5 AMP
5 VDC
0/30 MV
Tariff Code: 8538903000
Country of Origin: United States
POINT I/O 4 Point Analog Input Module
INPUT MODULE
POINT I/O
ANALOG
CURRENT
4 CHANNELS
OPEN STYLE
DIN RAIL MOUNT
PowerFlex 40- 4 kW (5 HP) AC Drive
22BD010N104
AC DRIVE
POWERFLEX 40
5 HP
4 KW
13 AMP
INPUT - 3 PHASE
48-63 HZ
460 VAC
OUTPUT - 0-400 HZ
Country of Origin: China
KPS60020ESC
DISCONTINUED BY MANUFACTURER
SERVO DRIVE
400-480 V AC
50/60 HZ
STATUS LEDS
DUAL ETHERNET PORTS
SCREW TERMINALS
UCN Dual Fan
51303940150
DISCONTINUED BY MANUFACTURER
DUAL FAN
0.25 AMP
120 VAC
WITH ALARM
3 BLADES
3100 RPM
3300 NSv Extension Cable
065 6.5 meters (21.3 feet)
01 With stainless steel armor
withFEP jacket
05 Multiple Approvals
3300 XL 50 mm Proximitor Sensor
3300 XL 50 mm Proximitor Sensor
9 0 9.0 meters (29.5 feet) systemlength
panel mount
0 0 No Approvals
Vibration Transmitter
0 5 0-5 mils pp (0-125 μm pp)
5 0 5.0 metres (16.4 feet)
0 2 Bulkhead screws
0 1 CSA Division 2
Power : Requires +12 to +35 Vdc
input at the transmitter terminal.
Maximum Loop Resistance :
1,000 Ω including cable at 35 Vdc.
Current Limiting : 23 mA typical.
Vibration Transmitter
0 5 0-5 mils pp (0-125 μm pp)
5 0 5.0 metres (16.4 feet)
0 1 35 mm DIN rail clips
0 0 Not required
Power : Requires +12 to +35 Vdc
input at the transmitter terminal.
Maximum Loop Resistance :
1,000 Ω including cable at 35 Vdc.
Current Limiting : 23 mA typical.
MVI94MCMMHI
MODBUS MASTER/SLAVE COMMUNICATION MODULE
SINGLE SLOT 1794 BACKPLANE COMPATIBLE
20 MA @ 5 VDC
12VDC TO 24VDC
340MA TO 170 MA
Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.