








FSC Termination Module
1031311
DISCONTINUED BY MANUFACTURER
HONEYWELL
10313/1/1
TERMINATON MODULE
FSC
Four Channel Control Card Catalytic Input
Power Consumption: 12.8W 8.5W
Drive: Constant Current.
Initial Accuracy: ±1%.
Electronic in 1mA stepsfrom 90 to 315mA.
Maximum Drive Voltage: 10V
Protected against short circuit and open circuit.
40 ohms (including sensor) at 200mA.
Full Scale Signal Range: 15mV to 300mV
±100mV from centre at 2V bridge voltage.
Adjustment: Electronic adjustment
of bridge balance and signal gain.
Open circuit. Short circuit single bead failure.
ENGINEERING CONTROL CARD
05701A0361
ENGINEERING CONTROL CARD
18-32 VDC
1.5W
13.2CM. X 2.5CM X 17CM
DC Input Card
Input Voltage Range: 12V DC to 48V DC
Input Channels 8 to 16 isolated input channels
Low State: ≤ 5V DC
High State: ≥ 10V DC
Operating Temperature: -10°C to +60°C
Storage Temperature: -40°C to +85°C
Humidity: 5% to 95% non-condensing
I/O MODULE
TKIOLI01
I/O MODULE
I/O LIM
24 VDC
Product type : Direct Control Systems
IOLIM (IIOLIM (/O Link Module)
Interface for PMIO
For complete information

Copyright Notice © 2004-2024 amikong.com All rights reserved
Disclaimer: We are not an authorized distributor or distributor of the product manufacturer of this website, The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because our company is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply.While many DCS PLC products will have firmware already installed, Our company makes no representation as to whether a DSC PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Our company also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from our company, its distributors, or any other source. Our company also makes no representations as to your right to install any such firmware on the product. Our company will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.