ABB Advant OCS and Advant-800xA

INPUT BRIDGE CONTROL BOARD

Model Number: AINP-01C
ABB Product Number: 68258529
Dimensions: 11.5x8x2cm
Weight: 0.04kg
Voltage Rating: Suitable for 208-690V applications
Coating: Coated for enhanced durability

Circuit Interface Board

AINT02C
DISCONTINUED BY MANUFACTURER
INTERFACE BOARD
FOR INVERTER

IGBT Inverter Module

Voltage Rating:1200V
Current Rating:300A (continuous)
Max Junction Temp.:150°C
Switching Frequency:Up to 20kHz
Gate Drive Voltage:+15V/-5V
Isolation Voltage:2500V RMS
Protection Features:DESAT, UVLO, OT

CONTROL BOARD

CONTROL BOARD
68789010
230/500V
COATED

Digital I/O Extension Module

Digital I/O Extension Module 
contains 2 digital inputs and 2relay outputs
2IN 24-250VDC 2OUT 250VAC

GATEWAY MODULE

IOR810
INTERFACE MODULE
GATEWAY MODULE
HNET TO S800
6 STATUS LEDS
FRONT STOP/RESET PIN

GATEWAY MODULE

PHBIOR80010000
GATEWAY MODULE
HNET TO S800
6 STATUS LEDS
FRONT STOP/RESET PIN

AF100 Optical Modem

3BSE002253R1
MODEM OPTICAL

DSTD197 Connection Unit

EXC3BSE004726R1
DSTD197
CONTROL SYSTEM
ADVANT OCS WITH MASTER SW
ADVANT CONTROLLER 450
I/O MODULES
Tariff Code: 8538907080 
Country of Origin: Sweden

TK811V015 POF Cable 1.5m Duplex

Wavelength:650 nm (visible red light)
Attenuation:≤ 3.5 dB/km (max)
Bandwidth:≥ 5 MHz/km
Numerical Aperture (NA):0.50 ± 0.02
Polarity:Keyed cross-over (Tx → Rx)
Jacket Material:Orange PVC (UV-resistant, flame-retardant)
Bend Radius: 15 mm (static) / ≥ 30 mm (dynamic)
Tensile Load:≤ 70 N 

CEX-Bus Terminatior

3BSC950193R1
CONNECTOR
CEX-BUS
TERMINATOR TB850
25PIN
DB25P
MALE

PP885 High Performance Touch Panel 15.4"

3BSE069276R1
DISCONTINUED BY MANUFACTURER
OPERATOR INTERFACE
15.4IN TOUCH PANEL
TFT 1280X800 (16:10)

15-inch TFT HMI panel

Powder-coated aluminum
Touch screen: Polyester on glass 1 million finger 
touch operations.Overlay: Autotex F157/F207
25-pin D-sub contact
chassis-mounted female 
withstandard locking screws 4-40 UNC
 9-pin D-sub contact
male with standard locking screws 4-40 UNC

Processor unit

CPU: Dual-core, 1.2 GHz
Flash Storage: 4 GB 
Ethernet Ports: 2x 10/100/1000 Mbps
Input Voltage: 24V DC 
Power Consumption: 15W typical

OPERATOR INTERFACE

OPERATOR INTERFACE
PROCESS PANEL SERIES
24 VDC
0.35 AMP(PP235)

Compact Terminal block

Compact installations of I/O modules
Field signals and process power connections
Connections to ModuleBus and I/O modules
Mechanical keying prevents insertion of the wrong module
Latching device to DIN rail
DIN rail mounting

Module Termination Unit

3BSE022460R1
DISCONTINUED BY MANUFACTURER
TERMINATION UNIT
TU846
Country of Origin: Sweden

TU838 Extended Module Termination Unit

3BSE008572R1
PLC MODULE
TU838
TERMINAL EXTENDED MODULE
50V

Compact Module Termination Unit

Up to 32 channels of field signals
Connections to ModuleBus and I/O modules.
Mechanical keying 
DIN rail for grounding
DIN rail mounting

SD834 Power Supply Device

Input a.c. 100-240 V or d.c
110-150 V. Output 
d.c. 24 V 20A
If redundant power application 
is required connect to SS8XX voting unit
DIN rail mounted
G2 compliant

Pulse Counter or Frequency Measurement Module

8 channels
The modules can be used in 
both single and redundant applications
Interface for NAMUR, 12 V and 
24 V transducer signal levels
Each channel can be configured for 
pulse count or frequency measurement
The inputs can also be read as DI signals
Pulse count by accumulation in a 16 bit counter
Frequency (speed) measurement 0.5 Hz - 20 kHz
Advanced on-board diagnostics

Analog Output Module

Input impedance:2.5 kΩ 
Maximum field cable length:200 meters (218 yards)
Rated insulation voltage:50 V
Dielectric test voltage:500 V a.c.
Power dissipation:2.5 W
Current consumption +5 V Modulebus:120 mA

Digital Output Module - 24Vdc

Digital Output Module - 24Vdc

Digital Output Module

3BUR001455R1
DIGITAL OUTPUT MODULE
CURRENT SINKING
DO814

Digital Input Module

NAMUR inputs
G3 compliant
Output status indicators
state upon error detection
Intrinsic Safety support
Short-circuit protection to ground and 30 V
8 channels with process voltage supervision
OSP sets outputs to predetermined 
Over-voltage and over-temperature protection