CANopen
Modbus RTU
PROFIBUS DP
Input Voltage Range: 24 V DC
Operating Temperature: -25°C to +70°C
Storage Temperature: -40°C to +85°C
Humidity: 5% to 95% (non-condensing)
Bulletin Number:PowerFlex 753 AC Drive
with Embedded I/O
Corrosive Gas Protection and Cooling Type:
Standard Protection, Forced Air
Voltage Class:400 VAC, 3 PH
Output Current:8.7 Amps,
(Fr1 4kW ND, 2.2kW HD/Fr2 4kW ND, 4kW HD)
Enclosure Type:Open Type
Input Type:AC Input with DC Terminals
Frame Size:Frame 2
EMC Filtering Options:Filtered, CM jumper installed (preferred)
Dynamic Braking:DB Transistor
HIMBlank (No HIM)
Supply Voltage:48 V dc
AC or DC Operation:DC
Power Consumption:40W
Air Flow:600m³/h
Noise Level:69dB
Fan Speed:7000rpm
Sensor Type:PWM, Tachometer
Bearing Type:Ball
Supply Voltage: 24V DC ±10%
Power Consumption: <15W typical
Voltage ranges: ±10V
Current ranges: 0-20mA
Resolution: 16-bit (minimum)
Sampling Rate: Up to 1kS/s per channel
Accuracy: ±0.1% of full scale
Isolation: 1500V AC
Input Voltage: Typically 24V DC
Operating Voltage Range: ±15V DC
Current Consumption:<500mA
Isolation Voltage: 1000V AC
Fiber optic or optocoupled signals
Digital I/O (for control signals)
Logic Side: 5V DC
Isolated Side: 15V DC
Current Rating: Typically <1A
Reinforced isolation:≥2500V AC
High-speed digital signals
Analog inputs:0-10V, 4-20mA
Input Voltage:230V AC
Range: Typically ±15%
Output Voltage:+24V DC
Auxiliary Outputs: ±15V DC
Efficiency: >85%
Isolation: 2500V AC
Terminal blocks for AC input and DC output
Multi-pin headers for control signals
330103 3300 XL 8 mm Probe
M10 x 1 thread,without armor
Minimum unthreaded length: 40 mm
Minimum case length: 130 mm
10 1.0 meter (3.3 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
330102 3300 XL 8 mm Probe
3/8-24 UNFthread, with armor
Minimum unthreaded length: 0.0 in
Minimum case length: 4.8 in
05 0.5 meter (1.6 feet)
02 Miniature coaxial ClickLocconnector
standard cable
00 Not required
Series: Mark VIe
Microprocessor: Intel Celeron 650 MHz
Number of inputs: 8
Power supply voltage: 28 V dc
Memory: 128 MB SDRAM
Number of outputs: 2
LVDT Excitation Output: 3.2 kHz
Programming: Boolean
Product Type: Simplex Servo Control I/O Module
Proximitor (Demodulator): 3300 XL NSv
Measurement Range: 0 to 40 mils (0 to 1.0 mm)
Sensitivity: 200 mV/mil (7.87 V/mm) ±5%
Frequency Response: 0 to 10 kHz
Gap Voltage (Vgap): -10 V DC
Linearity: ±1% of full scale
Power Supply: -18 to -26 V DC
Output Signal: -2 to -18 V DC
Input Voltage:230V AC
Range: -15% to +10% of nominal
Frequency: 50/60Hz ±5%
Output Voltages:+24V DC (±1%)
Current Ratings:24V DC
Efficiency: >88% at full load
Ripple: <1% of nominal output voltage
Processor: 32-bit RISC processor
Memory:8MB RAM
Power Supply: 24V DC ±10%
Power Consumption: <15W
Operating Voltage Range: 18-30V DC
Screw terminals for power
BNC or ST-type fiber for Infi-net
DB9 or DB25 for serial
RJ45 for Ethernet (if equipped)
Input: 3x 380 to 480 VAC ±10%
Output voltage adjustable via X2X Link
Status information readable via X2X Link
Chopper output for connecting an external braking resistor
3-phase wide range input
Closed metal housing
0 5 0-5 mils pp (0-125 μm pp)
0 1 35 mm DIN rail clips
0 5 CSA Division 2, ATEX Zone 0,
ATEXZone 2 and includes ABS maritimeapproval
Power : Requires +12 to +35 Vdc
input at the transmitter terminal.
Maximum Loop Resistance :
1,000 Ω including cable at 35 Vdc.
Current Limiting : 23 mA typical.
Local Bus Power 12 VDC at 150 mA
Bussed Field Power 24 VDC at 3.2 A/Card
Field Circuit 24 VDC at 100 mA/Ch
Ambient Temperature -40 °C to +70 °C
Shock 10 g half-sine wave for 11 ms
Vibration 1 mm peak to peak from 2 to 13.2Hz;
0.7 g from 13.2 to 150 Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3
Number of Channels: 16 connection points
Isolation: 250V AC
Rated Voltage: 250V AC/DC
Current Rating: 2A per channel
Contact Resistance: <50mΩ
Insulation Resistance: >100MΩ @ 500V DC
Dielectric Strength: 2000V AC (50Hz)
Frequency range: 1Hz-20kHz
Input sensitivity: 50mV RMS minimum
Isolation: 1500V AC between channels
Analog Inputs:4-20mA position
Control Outputs: 4-20mA governor control signal
Power Supply:24VDC nominal
Accuracy: ±0.1% of reading ±1 RPM
