ALL MANUFACTURERS

SC S300 SAFETY CONTROLLER SIL3

Input Voltage: 24 VDC (±10%)
Output Voltage: 24 VDC
Current Capacity: Typically up to 5A
Operating Temperature: -40°C to +70°C (-40°F to +158°F).
Humidity: 5–95% non-condensing

SC S300 SAFETY CONTROLLER SIL3

Digital Inputs:24 VDC
Cycle Time: <10 ms 
Operating Temperature: -20°C to +60°C (-4°F to +140°F)
Contact Rating: 5A @ 250VAC
Operating Force: 1.8N minimum
Release Force: 0.1N minimum
Pre-travel: 1.5mm maximum

DeltaV 8-Port Ethernet Switch

Copper Ports: 6 × 10/100/1000Base-T RJ45 
Fiber Ports: 2 × 100/1000Base-X SFP 
Total Ports: 8 ports
Input Voltage: 24 VDC
Power Consumption: Typically <15W
Switching Capacity: 16 Gbps
Packet Forwarding Rate: 11.9 Mpps.
MAC Address Table: 8K entries.
Jumbo Frames: Support up to 9.6 kB

HVD BOARD

Voltage Rating:  3.3 kV, 6.6 kV
Control Voltage: 24 VDC
Power Consumption: <20 W
Operating Temperature: 0°C to +55°C
Humidity: Up to 95% RH (non-condensing)

CPU module

Series:RX3i PacSystem
Part Number:IC695CPE330-AFAT
Product Type:CPU module
Processor Clock Speed:1.0 Ghz
RAM:64 MB
NVRAM:64MB
I/O Points:up to 32 K I/O
Controller Redundancy:Supported
Maximum Program Blocks:512
Maximum Block Size:128 kilobytes

SERVO DRIVE

SERVO DRIVE
18 AMP
3 PHASE
48 VDC
180 WATT
3 SINUS POWER

SAFETY CENTRAL MODULE

Use in the PES H41q-MS, -HS, -HRS
Safety-related, applicable 
up to SIL 3 according to IEC 61508
Microprocessors INTEL 386EX, 32 bits
Clock frequency 25 MHz
Data SRAM 1 MB
Space requirement 8 SU
Operating data 5 V / 2 A

I/O TERMINAL BLOCK

FISHER-ROSEMOUNT EMERSON
12P0623X062
I/O TERMINAL BLOCK
KJ4001X1-CA1

Analog Output Module

S-Series AO 4-20 mA HART 8-Channel
Local Bus Power 12 VDC at 150 mA
Bussed Field Power 24 VDC at 300 mA
Field Circuit24 VDC at 23 mA/Channel
Ambient Temperature -40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz
0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3

Analog Output Module

S-Series AO 4-20 mA HART 8-Channel
Local Bus Power 12 VDC at 150 mA
Bussed Field Power 24 VDC at 300 mA
Field Circuit24 VDC at 23 mA/Channel
Ambient Temperature -40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz
0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3

32 Channel Terminal Block

Input Power Rating 30 VDC @ 1 A
AmbientTemperature-40 °C to +70 °C
Shock 10 g half-sine wave for 11 ms
Vibration 1 mm peak to peak from 2 to 13.2 Hz
0.7 g from 13.2 to 150 Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3
Relative Humidity 5 to 95% non-condensing

Analog Input Module

ANALOG MODULE
2 WIRE/16CHANNEL
4-20MA
SERIES 2
LOCALBUS POWER RATING: 12VDC AT 150MA
BUSSED FIELD POWER RATING: 24VDC AT 600MA
FIELD CIRCUIT RATING: 240VDC AT 30MA
RACK MOUNTED

CARD-COMPACTFLASH

Capacity: Typically 512 MB 
Interface: CompactFlash Type 3.3 V or 5 V
Sustained read: Up to 10-15 MB/s
Sustained write: Up to 8-12 MB/s

Redundant H1 Terminal Block

I/O Count 20 points
Input Type:120V ac
Analog Circuits:4 Inputs, 1 Output
Protocol:DF1
Safety Feature:Master Control Relay
Digital Outputs:8 Contact Outputs
No. of Discrete Inputs:Twelve (12)
Input Voltage Type:120 Volts AC
Voltage Range:79-132 Volts AC
Output Type:Eight (8) Relay

Redundant H1 Terminal Block

Input Power Rating 35 VDC @ 500m A
AmbientTemperature-40 °C to +70 °C
Shock 10 g half-sine wave for 11 ms
Vibration 1 mm peak to peak from 2 to 13.2 Hz
0.7 g from 13.2 to 150 Hz
AirborneContaminantsISA-S71.04 –1985 Airborne
Contaminants Class G3
Relative Humidity 5 to 95% non-condensing 

Fieldbus H1 Card

Local Bus Power 12 VDC at 300 mA
Fieldbus Power 9 to 32 VDC at 12 mA/Port 
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec 
Vibration 1mm Peak to Peak from 2 to 13.2Hz;0.7g from 13.2 to 150Hz 
AirborneContaminantsISA-S71.04 –1985 AirborneContaminants Class G3
Relative Humidity 5 to 95% Non-Condensing IP 20 Rating 
Terminal Block keyPosition D6  

Interface Terminal Block

Field Power 35 VDC at 1 A 
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec
Vibration 1mm Peak to Peak from 2 to 13.2Hz;0.7g from 13.2 to 150Hz
AirborneContaminantsISA-S71.04 –1985 AirborneContaminants Class G3
Relative Humidity 5 to 95% Non-Condensing 
Terminal Block Key Position Set according to I/O card installed 

Serial Interface Module

SERIAL INTERFACE CARD
12 VDC
300 MA
2 PORT
D4 TERMINAL BLOCK KEY POSITION
Simplex SIC (Serial Interface Card), 
LocalBus Power Rating 12 VDC 300mA
Ambient Temperature -40 to 70 degrees C

ADAPT Aeroderivative Monitor

Displacement: 0–500 µm peak-to-peak
Velocity: 0–20 mm/s RMS
Acceleration: 0–50 g peak
Frequency Response: 0.5 Hz to 30 kHz
Sampling Rate: Up to 100 kHz 
Operating Temperature: -40°C to +85°C 

Wind Turbine Monitor

Vibration Velocity: Typical range 0–20 mm/s RMS 
Vibration Acceleration: 0–50 g peak
Frequency Range: 0.5 Hz to 10 kHz
Speed Range: 0–3,000 RPM 
Analog Outputs: 4–20 mA 
Operating Temperature: -40°C to +85°C 
Voltage: 18–30 VDC
Power Consumption: <5 W

Wind Turbine Monitor

Vibration Velocity: Typical range 0–20 mm/s RMS 
Vibration Acceleration: 0–50 g peak
Frequency Range: 0.5 Hz to 10 kHz
Speed Range: 0–3,000 RPM 
Analog Outputs: 4–20 mA 
Operating Temperature: -40°C to +85°C 
Voltage: 18–30 VDC
Power Consumption: <5 W

PowerFlex 753 AC drive

Series:PowerFlex 753
Frames:1..5, 8...10
Enclosure Type:AC and DC Input with Precharge
Frames:2 2...7
Enclosure Type 2:IP20/IP00, NEMA/UL Type Open
Voltage:400 Volts AC/540 Volts DC
Horsepower:300
Filtering:Yes
Default CM Cap Connection:Jumper Installed

Frequency drive

PowerFlex 753 AC Drive
with Embedded I/O, Standard Protection
Forced Air, AC Input with DC Terminals
Open Type, 37 Amps, 18.5kW ND
15kW HD, 400 VAC, 3 PH, Frame 3
Filtered, CM jumper installed (preferred)
DB Transistor, Blank (No HIM)

Frequency drive

PowerFlex 753 AC Drive
with Embedded I/O, Standard Protection
Forced Air, AC Input with DC Terminals
Open Type, 30 Amps, 15kW ND, 11kW HD
400 VAC, 3 PH, Frame 3, Filtered
CM jumper installed (preferred)
DB Transistor, Blank (No HIM)

Frequency drive

Part Number/Catalog No.:20F11NC015JA0NNNNN
Series:PowerFlex 753
Frames:1..5,8...10
Enclosure Type:AC & DC Input w/Precharge
Frames:2 2...7
Enclosure Type 2:IP20/IP00, NEMA/UL Type Open
Voltage:400V AC/540V DC
Filtering:Yes
Default CM Cap Connection:Jumper Installed