ALL MANUFACTURERS

Control Unit

SIMOTION Drive-based Control Unit D435-2 DP/PN
programmablemotion controller
STANDARD performance
interfaces: 12 DI, 16DI/DO, 6 DRIVE-CLiQ
2 PROFIBUS, 3 PROFINET ports
2 ethernet,2 USB, 1 option slot
incl. dual fan / battery module and battery

Output interfaces Module

OUTPUT CARD
FOR MULTI-PARALLEL CIRCUIT
SIMOVERT MASTERDRIVES
Digital Outputs:24V DC
Analog Outputs:0/4-20mA
Supply Voltage: 24V DC
Relay contacts: 250V AC
Transistor outputs: 24V DC
Voltage: ±10V, 12-bit resolution
Current: 0/4-20mA

Communication interface board

Communication interfaces Module
for multi-parallel Circuit
Data Transfer Rate: Up to 12 Mbps
Interface Type: RS-485
Supply Voltage: 24V DC

INTERFACE MODULE

INTERFACE MODULE
FOR MULTI-PARALLEL CIRCUIT
SIMOVERT MASTERDRIVES
Supply Voltage:24V DC ±10%
Power Consumption:8W (typical)
Isolation Voltage:2500V AC
Data Rate:1Mbps
Fiber Type:50/125μm multimode

Rectifier interfaces Module

Supply Voltage:24V DC ±10%
Power Consumption:15W (max)
Isolation:2500V AC 
Response Time:<100μs (fault signals)
Communication Rate:1Mbps (fiber-optic)
Temperature Monitoring:±1°C accuracy

Circuit Board

Supply Voltage:24V DC ±10%
Power Consumption:5W (max)
Isolation Voltage:1500V AC )
Communication Speed:Up to 12Mbps
PROFIBUS DP:9-pin D-sub

CORDSET

CORDSET
40-WAY TERMINAL
TWO ENDS FLYING LEADS
FOR M340 I/O
3 M CABLE LENGTH

RACK

RACK
12 SLOTS
ETHERNET BACKPLANE
0 TO +60 DEGREES C
IP20 ENCLOSURE PROTECTION
RECOMMENDED REPLACEMENT FOR 140XBP01600

PROCESSOR MODULE

PROCESSOR MODULE
MODICON M580
24 VDC
295 MA
NUMBER OF RACKS: 8
768 I/O PROCESSOR CAPACITY
LED INDICATORS
-40 TO +85 DEGREES C
IP20

TF Extended SINEC H1 Module

SIMATIC NET CP 1430 
TF Communications processor 
for Connection of SIMATIC S7-300 
to Industrial Ethernet extended-Version 1ms 
Time accuracy

Digital input module

SIMATIC S5
Digital input 431 for fail-safe
Isolated for S5-95F
8 inputs 24 V DC

3300 NSv Proximity Probes

330901  3300 NSv Probe
1/4-28 UNF thread,without armor
Minimum unthreaded length: 2.0 in
Minimum case length: 3.2 in
10 1.0 meter (39 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals

3300 XL 8 mm Proximity Probes

330103  3300 XL 8 mm Probe
M10 x 1 thread,without armor
Minimum unthreaded length: 100 mm
Minimum case length: 120 mm
05 0.5 meter (1.6 feet)
11Miniature coaxial ClickLocconnector 
with connectorprotector, FluidLoc cable
05 CSA, ATEX, IECEx  Approvals

Standard Interconnect Cable

Conductors: 3 × 22 AWG (0.5 mm²) 
Capacitance: ≤100 pF/m
Length Range:25ft
Shielding: Braided copper shield (≥85% coverage) 

3300 NSv Proximity Probes

330905 3300 NSv Probe
M10X1 thread,without armor
Minimum unthreaded length:0 mm
Minimum length: 90 mm
05 0.5 meter (20 in)
02 Miniature coaxial ClickLoc connector
standard cable
05 Multiple Approvals

REV H DIODE SUPPLY CONNECTOR BOARD

Input Voltage: 24V DC
Output Voltage: ±15V DC
Current Rating: ≤ 2A per
Isolation Voltage: ≥ 2500V AC
Input: 6–10-pin terminal

VEHICLE CONTROL UNIT

Supply Voltage: 24V DC
Power Consumption: Typically < 50W
Isolation: 1500V AC
Digital I/O: ≥ 24 channels
Analog I/O: ≥ 8 channels
Relay Outputs: ≥ 8

Discrete Input Card

S-Series DI 32-Channel 24 VDC 
Dry Contact Card
Input Voltage Range:5–60V DC (24V DC nominal)
On-State Threshold:≤ 5V DC (logic "1")
Off-State Threshold:≥ 15V DC (logic "0")
Input Impedance:3.3 kΩ (typical)
Input Current:≤ 8 mA @ 24V DC (per channel)
Max Continuous Voltage:60V DC
Isolation:Group-to-Group: 300V AC RMS

Analog Input Module

Channels: 8
Signal Type: 4–20 mA DC
nput Range:4–20 mA DC (configurable for 0–20 mA)
Overrange Capability: -1 mA to +25 mA
Input Impedance:≤ 250 Ω (typical)
Accuracy:±0.05% of span (at 25°C)
Temperature Drift:±0.005% of span/°C (-40°C to +70°C)
Resolution:24-bit 

AO 8-Channel 4-20 mA HART Card

AO 8-CHANNEL 4-20MA HART CARD
12P4704X032
Channels: 8
Signal Type: 4–20 mA DC
Output Range:4–20 mA DC 
Load Resistance:300–1100 Ω
Accuracy:±0.1% of span (25°C)
Temperature Drift:±0.02% of span/°C (-40°C to +70°C)
Resolution:15 bits (including sign)

Redundant AI 8-Channel TerminalBlock

Signal Type: 4–20 mA DC
Standard: 4–20 mA DC
Overrange: -5 mA to +25 mA
Input Impedance: ≤ 250 Ω (typical)
Field Power 30 VDC at 200 mA
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec

8-Channel Terminal Block

TERMINAL BLOCK REDUNDANT INTERFACE
Field Power   30 VDC at 100 mA 
AmbientTemperature-40°C to +70°C
Shock 10g ½ Sinewave for 11msec

DIGITAL INPUT MODULE

DIGITAL INPUT MODULE
NAMUR CARD
8-CHANNEL
LOCALBUS POWER 12 VDC AT 150 MA
(12P4692X042)

Safety Remote Output Module

Response time :≥ 20 ms 
Current input max. 0.6 A 
Fuse (external) 10 A time-lag (T) 
Back-up battery None
Operating voltage 24 VDC, -15...+20 %, rPP ≤ 15 %
Switching voltage  5 V,  250 VAC / 250 VDC 
Number of channels 8 potential-free normally open contacts

WIRING SYSTEMS MODULES

1492 SERIES
40 PINS
FUSIBLE
WIRING SYSTEMS MODULES
ISOLATED EXTRA TERMINALS FOR OUTPUTS
DIGITAL MODULE WITH FIXED TERMINAL BLOCK
TWOPER I/O CONNECTION